2002 Yamaha TT-R 125 Logo
Posted on Jun 01, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

TTR 90 wont start. Not carb. Not CDI. Plug cap?

TTR 90E 2005 Will not start even with starting fluid. Ruled out the carb. Ruled out CDI box (replaced). Checked ignition switch, kill switch and coil impedances. Plug wire measures 8.5K ohms. Plug cap measures over 8K ohms as well (removed from wire). Is this right? The manual doesn't give a number for the plug cap impedance.

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Master 957 Answers
  • Posted on Jun 01, 2009
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: Apr 24, 2009
Answers
957
Questions
0
Helped
490901
Points
3205

Every component plays a part in the ignition system. Check the wiring as you go. Start at one end and move forward. You have done a lot of work so far. so you should be close. If the igniter is fine and the other components too. Then it would narrow it down to an electrical problem or no signal/pulse to the coil. See if the coil is receiving that pulse. you can use a test light for this test. Pos. will be power and NEG. will be the pulse. With light on the NEG. crank the engine over and see if it flashes. Let me know how its going.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Ttr 90 wont stay running and makes a ringing noise

Is the idle properly adjusted? The ringing is normal for a 2-stroke.
0helpful
1answer

Yamaha ttr90 no spark

Test the stator those go in them quite a bit
0helpful
1answer

Take to long to start.. takes almost ten minutes of kick starting... electric starter wont turn over to start bike yamaha ttr 125

The TTR-125 Carburetor's Run Lean by design. Mine had the same issues till I found a post on Thumpertalk.com on Carb and air box Mod. This is a good starting point on gets; 110 and 112.5 main and 17.5 pilot. But you must check spark plug coloring to make sure the jetting is correct. Check spark plug after the bike has been ridden for a wile. I also took out the stock baffle and replaced it with exhaust tip and now it fires up after a few kicks and worms up in a few minutes.
0helpful
1answer

92 virago 750. Front cylinder runs intermittently. Coil is good. I cleaned carbs. Suspect CDI. Seems to run fine until it warms up. I recently put new Voltage Regulator in. Stator is not shorted. and...

You have to test all the electronics on the bike to figure out if you have a bad CDI box. A CDI box can test good and still be bad. Your problem sounds more like a bad spark plug cap. Unscrew the cap from the end of the wire and take an OHM reading on the cap. If it is higher or lower than 5000 OHMs replace the cap . A plug cap from NGK runs about $5. Replace them both for about $10 it should take care of the problem.
0helpful
1answer

Apache rlx300 wont start spitting back through carb

check spark,timing from side case side,then swap spark plug,try to bypass spark cap,then check flow of petrol to carb,clean carb and allow to cool if needed.Sometimes a coil just dies for no apparent reason..The last resort is to swap the coil inside the side case...
3helpful
4answers

I have a Baja 90 atv that wont start, have good spark & fuel but doesn't want to start

take the jumper off of the cdi box located under the fuel tank. unplug the cdi unit and loosen the 2 screws with a phillips screwdriver to remove the jumper. then take off the rubber stoppers on the other end of the cdi unit and turn them clockwise to speed up the low and high setting.
2helpful
3answers

Ktm 450sxf 07 wont start

The decompression valve has come apart in the engine. Tear it down!
0helpful
1answer

07 ktm 450sxf wont start

take your carb out, clean the entire thing, that means every nook in that *****. do this and if still a problem write back because in most cases were n idiot is involved, this is the most over looked problem
Not finding what you are looking for?

1,716 views

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...