Speedometer stopped working on 2001 Victory Motorcycle

RECALL ID# 37410 - POWER TRAIN:MANUAL TRANSMISSION gives you a place to go or call...
Recall Date: August 07, 2006
Model Affected: V92 Component Affected: POWER TRAIN:MANUAL TRANSMISSION Recall Summary: CERTAIN MY 2001 VICTORY V92 MOTORCYCLES, AND 1999-2000 V92 MOTORCYCLES THAT RECEIVED TRANSMISSION REPLACEMENT KITS BUILT IN 2001 CAN EXPERIENCE A THIRD GEAR FAILURE IN AN ABNORMAL OVERLOAD CONDITION SUCH AS WHEN SHIFTING AT HIGH RPM. Consequence: WHILE SHIFTING GEARS AT HIGH RPM, THE THIRD GEAR MAY FAIL. IF PIECES OF THE FAILED GEAR BECOME LODGED IN THE TRANSMISSION, THE TRANSMISSION COULD LOCKUP POSSIBLY RESULTING IN LOSS OF CONTROL AND A CRASH. Remedy: DEALERS WILL INSTALL A REAR SPROCKET DAMPER ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON NOVEMBER 22, 2006. OWNERS MAY CONTACT POLARIS AT 763-417-8650. Potential Motorcycles Affected: 2523

Check if it uses cable or if it electronic.
If it uses cable the lower end is attached on the front wheel axle.Maybe you have to buy a new cable.
If it is electronic usually it senses the pulse from the gearbox (the sensor is towards the swingarm).

Speedometer stopped working on 2001 Victory Motorcycle had the same problem after finding out the voltage going to speedo was very low i used a 1 1/2 volt battery unhook speed sensor used 2 wires one from ground going to ground side of the 1 1/2 AA battery and the other from power side going to signal side to the speedo that would be the center wire for a 3 wire sensor dont hold the wire on tape it on the power side of the battery you should see the speedo work this will tell you if it is the speedo or the sensor but make sure you have the 12 volts going to the sensor the to outer wires.you can't check the sensor i found out I needed a sensor to fix my problem 100.00 for a sensor 400.00 for a speedo.