2004 Honda XR 125 L Logo

Related Topics:

Posted on May 27, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Engine noise I have an engine noise like a rattle in head sounds like is this normal. honda xr 125l 04. thanks

1 Answer

tbrat44

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Hot-Shot:

An expert who has answered 20 questions.

  • Expert 86 Answers
  • Posted on May 27, 2009
tbrat44
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Hot-Shot:

An expert who has answered 20 questions.

Joined: May 06, 2009
Answers
86
Questions
0
Helped
42474
Points
245

Sounds like it could be 2 things. the valve tappets, meaning valves need adjusting and or loose cam chain which may need adjusting.

  • arranmachaye Jan 15, 2012

    There is no cam chain dump arse

×

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Honda xr125 L blowing 15amp fuse while i was riding no lights or starter or horn

Sounds like a short like the insulation on wire rubbed off. Could also be a loose connection on either the hot or ground side of light circuit. This would blow a fuse.
0helpful
1answer

Honda xr 125 blowing 15amp fuse

me id start by looking real close at the wires to and from the head and tail lamps and handle switches , then id go farther at looking inside the head and tail lamp housings for say water or a rusty or damaged wire , finnaly arriving at looking at the battery voltage with a voltmeter when im reving engine this shouldn't go over say 12.8 volts if it does your voltage regulator is defective and is damaging all your bulbs
0helpful
1answer

How to change oil on a 2008 honda xr 125L

Undo the 17mm bolt in the middle of the engine on the underside, catch the old oil in a clean container, check the condition of the crush washer on the drain plug, replace if ness, when all the oil has been drained replace the drain plug and tighten adequatly, refill the engine using the correct oil.To the rite level
.start up the engine allow it to run for a few mins, then turn the ignition
To the off position, allow to settle hold bike in uprite postion and. Recheck the level as per handbook
1helpful
1answer

I have a honda xr 125l 2003 which i bought in june only to find out the cylinderhead was damaged by the valve head which broke and hit the piston head. now i bought the cylinder head of cg 125 with the...

Hello epsom...you really should purchase the shop manual so you could see the illustrations and the step by step procedures on how to align timing marks and properly gap your piston rings. Plus so much more info that you are going to need to do the job right. Plus the manual has the torque specs. and the sequence---There is not enough room here to give you all the info u will need. Here is a link for the manual online, you might can find it a bit cheaper on Amazon. i hope this helps.

http://cgi.ebay.com/ebaymotors/Honda-XL-XR-125-200-Motorcycle-Service-Repair-Manual-/260718595181
0helpful
1answer

Low mileage honda with only 1,200orig mi ..clutch plates making a little rattle noise when ideling

All Honda's make a rattle sound at idle. It goes away when you pull in the clutch lever or drive down the road. New or old , it is a normal sound for a Honda motorcycle. It did it when it was brand new and it will do it when it has 120,000 miles on it. Understand it, get used to it, any Honda rider will tell you there is no way to stop it . It is just a normal Honda sound.. Now go out and ride.
2helpful
1answer

Noise clutch area honda cbf 600 04 plate

This is normal, it is the clutch plates rattling, when u apply pressure it holds the plates tight.
Not finding what you are looking for?

1,103 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...