Dies when put in gear - Cagiva Motorcycles

airflow meter

Riding Mower Dies When Put in Gear ' ThriftyFun

www.thriftyfun.com/Riding-Mower-Dies-When-Put-in-Gear.html

It starts fine, but when I put it in gear to go forward or reverse it dies. It also dies ... The engine on my riding mower will start and run while the clutch is pushed in.

Starts and Runs but Dies When put in gear - YSR 50 ' South Bay Riders

www.southbayriders.com > ... > Community > Maintenance and Repair

Aug 25, 2010 - 15 posts - ‎4 authors
The bike will start and run perfectly fine. However, the moment I put it into gear it dies. ----------------- How we got to this point:...

Engine dies in gear, runs in neutral - Hot Rod Forum : Hotrodders ...

www.hotrodders.com > Tech Help > Engine

Jan 4, 2010 - 12 posts - ‎10 authors
But if I drop it into any gear besides neutral or park, the engine will ... In this case, it shifts fine, and on time, however acceleration is ... start. the engine idling rough and wanting to stall when put in gear is the indicator to me.

Check out the grass box safety switch. if not fully depressed it will apply brakes to the blades when in gear. Most mowers are designed with a safety switch to stop the blades, or forward motion if the grass box is not fitted correctly.

if it dies when put in gear, try giving it gas while holding the brake, them putting it in gear if it does not die then replace the idle control valve iac it located on top on the throttle body

This could be a couple of different problems. You said it dies after it gets warm. Is this just like when you stop at a stop sign? And you say it starts back up but dies when you put it in gear? If you restart it and leave it in park it won't die??? Just dies if you put it in gear? I think it might be your torque converter clutch solenoid.

try unplugging the one plug in front of trans it has 2 or 3 wires in it . its below the battery it is the lockup solinoid and they go bad and keep the trans in lockup mode and will do what your saying.

This sounds like the kick stand switch is bad or not making full contact.


Please take time to rate this a fixya

it sounds like timing to me if it dies when you put it in gear.it can idle fine but when you put it in gear and it dies then you have timing problems

check basics first - dist cap,rotor,plugs,etc.Then put a pressure gauge on fuel line and check reading to specs for truck. you may need a fuel pump