My flashers and my back light blink. when I put right flasher on the left one goes on and so does the back light
Sounds like a problem with the earth/ground side of the circuits the all have different power feeds but share the earth/ground connections
Hi there it sounds like you might have a earth problem ,clean the earth contacts on each of the electrical parts somtimes it might be just one earth is working and the rest are working off of that if you have repainted the frame then you need to clean the paint off of the area that has the earth lead.also clean the earth lead on the battery and to where it connects .cheers hopes this works
SOURCE: indicator problem
The flasher unit is called the TSSM module. It is a combined flasher and alarm unit. A new one will require your alarm keyfobs to be matched to it. An expensive unit if faulty. If you replaced the earth wires and now its blowing fuses, then I would check your work. The fault has changed after you worked on the vehicle so logic dictates you have caused this. The black wire is usually the earth on these indicators but it is a possibility that these are routed through the TSSM module. You might have done damage if this is so.
SOURCE: slow right turn signal on Kawasaki 800 Vulcan Classic.
there is only 1 flasher relay. unfotunately its a sealed type so you will have to replace it.
SOURCE: I keep blowing the accessory fuse on my electra glide
I'd say that you have an intermittant short somewhere. These are very difficult to find. I'd start at the tail light assembly as most of the time, I've found the shorts in that area, from the seat back to the tail light assembly.
Good Luck
Steve
117 views
Usually answered in minutes!
×