What is the fork oil capacity for a 2006 Derbi Senda 125 sm?
SOURCE: Drain and change oil
I can't tell you all the particulars from the limited amount of pictures of your bike. -Remove the oil drain bolt on the bottom of the crankcase (the universal bolt size for bikes use a 17mm wrench). -Drain the oil (remember to recycle). -Re-install the drain bolt with a new sealing washer if necessary. -The oil fill cap should be some where on the top of the crankcase. About 1 or 25mm in diameter with a raised tab for turning. -Fill with recommended oil. -There are 2 ways to check oil level on dirt bikes: 1) Oil level check bolt. On the right side cover. 2) Oil level site glass. A 1 round piece of glass on the side of the crankcase. Usually by the kick start & R brake lever. -Always check the oil level with the bike upright (as if you were sitting on it). -Check bolt - fill with oil slowly until oil comes out of the check bolt and re-install it. -Sight glass - fill with oil to cover 3/4 of the sight glass. -Remember to hold the bike upright when adding oil.,
SOURCE: what size is a derbi gpr 125 piston seal kit?
GPR125 '05 model engines have a piston of 56mm diameter
Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)
SOURCE: i want to have more horsepower
Hey. Replacing the stock cam with a performance camshaft will help. To gain more horsepower you should also make the airflow to the engine better. Replacing the stock sylinder with a big bore 150cc kit will sure make the engine more willing. The engine on a 08 Derbi senda baja model, is the same engine that you will find on a Yamaha TTR 125. So that is what you should search for. Hope it helps:)
SOURCE: my derbi senda 50 pro
first have the head trued at a machine shop then get new head bolts, clean mating surfaces spotless with a non residue cleaner such as brake clean DO NOT TOUCH ANY SURFACE AS YOUR FINGERS LEAVE DEPOSITS that includes the gasket, torque to manufacturer spec with lightly oiled bolts,
372 views
Usually answered in minutes!
×