My 2012 Aprilia Rs125 cut out & the back wheel locked up

SOURCE: 2006 Aprilia RS125 doesnt start

Hi .... Try switching the petrol off just prior to stopping the engine and start up again with the petrol OFF. There's enough petrol in the carb to start the bike. A good battery should show over 12 volts. Take the plugs out and give them a good clean or replace them. Is there a petrul pump fitted ? A two stroke needs to be ridden quite hard to maintain efficeincy, higher revs etc ........ let us know how you get on ?

SOURCE: i have an 07 aprilia

EFI is electronic fuel injection. Could be any number of reasons the light is on.

SOURCE: drilling a 2008 aprilia rs125 cdi unit

when you look at the cdi you should se a recess in the corner just a small little recess , enough for a small drill bit to fit , drill the small nipple located in the recess
and i am no expert , just persistent at researching the net

SOURCE: My aprilia rs125 2007 jus cut out on me and wont fire up again

• Start with a new spark plug. Now do you see spark? If not, check the side stand kill switch. It kills the engine so that you don’t start out with the side stand down. If broken or out of adjustment, it would kill the spark. Check for a broken wire at the side stand switch and coupler. Try moving the kill switch by hand. If that doesn’t work then wire a jumper around the switch to bypass it.
• Check the fuses. How good is the battery? Try a jump start from your car battery. Is the handlebar kill switch on?
• Check the operation of the ignition switch and all kill switches with a volt ohmmeter. Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center casing. If still no spark, get CDI system and coils checked at the dealers shop.
• Are the fuses good?

SOURCE: after changing the gearbox oil on my aprilia

It says in my rs 125 manual use sae 75w/90 gear oil so i would use that but if you have tryed to use different oil don't mix them both otherwise u'll need to be buying some new clutch plates.