SOURCE: Car starts then stalls once the engine warms up.
You need new timing belt and gears. Buicks gears are made of plastic, and become a big glob. Nothing for the timing belt to grab onto.
SOURCE: Starts fine, Idles fine, Drives Fine for a while
you might want to chk. the crank sensor and or cam sensor. sounds more to me that it could be fuel problem. chk. fuel pressure. pump could be on its way out. don't be fooled by hearing the pump running as they sound like they are pumping but there not, at least not enought pressure to keep it running. pressure should be around 50 p.s.i.
SOURCE: 2000 LeSabre starts but runs very rough and stalls. After
My 2002 Lesabre (app 115000 miles) started something like this. Also the loose gas cap had been coming on for quite a while. I replaced the vacuum line from the air intake to the fuel sensor. It is under the engine cover (twist off the oil filler to remove the cover). There are two hoses together that come of the air intake. The small one goes to the top of the engine. The other goes across the front and makes a 180 turn back to the sensor. Chances are the 180 piece is cracked. It all comes from the dealer as one unit. $25
Seems to have fixed my problems. So if your car is running a little rough. Shutters under load. If the gas cap loose is coming on or probably a number of symptoms this might be the answer. I would replace this item. A cheap try.
SOURCE: 97 buick lesabre 3.8 Idles rough and stalls out.
ignition system not operating properly ,or intake air leak ...crank engine get a can of staring fluid spray around the intake if the motor idles up you got a leak hope this helps
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
Engine stalling and rough run
issue at low speeds
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
169 views
Usually answered in minutes!
×