How to install motor mounts on 2000 Nisan Quest?

check egr tube hose

if you can find fuse box then with a test light earth clip to a good earth location(metal ign key works)touch pionty end of test light to one side of fuse then to the other. if the ignition is on and headlights on all fuses should light uptest light on both sides. if light on one side only fuse is blown

Nissan quest has a huge proble. I searched with google and many others to fidn this same problem. The over drive can cause the torque to slowly break the cheap motor mounts. If you replaced it yourself you know how cheap and weak they look. There are mroe expensive brands with lifetime warranties in which they last a good 4-5 years even with a lead foot aka my wife slamming on the gas everywhere lol. So look to a more expensive motor mount with a lifetime warranty. When someoen guarantees it for life they build it not to break :) sorry for spelling errors im on a tablet. Im havign a bundle of trouble with my quest, the vcr built in stopped working, blower motor went out replace fsu and blower switch in dash and next up is blower motor. Have fun nissan quest are great vahicles, cheap parts but a hell of a time diagnosing the problem. Good thing is its about 50 bux for a life time warranty front motor mount. A way to help stabilize it i did when racing is put a heavy duty chain around the bracket as well, wont hurt a thing and will save the life of your motor mount. Sounds rigged but works like a charm. I had to change a motor mount on my mustang form racing 1 time a month untill I put the chain on there with the new one.

Transmission mount, perhaps?

yahoo group for villager quest owners has files on this and part numbers. front ones break.

Get a piece of 2x4 and a floor jack. Support the bottom of the engine with the 2x4 under the oil pan. Slightly raise the jack untill slight tension is felt. Loosen the top motor mout bolts and remove the mount. Install the new mount lower the jack and retighten the mount. Do the same for the rear or bottom mounts witch ever applies. HTH

This is a difficult job and you should probably have a pro do it. Don't mean to discourage, just save you some grief in the long run. If you have a lot of experience and want to try it, this is probably the best site to check out:

http://home.earthlink.net/~vqfaq/

have the throttle body cleaned and adjusted. i would suggest taking it to the dealer for this procedure. you will notice a huge difference.

was the engine overheating before this repair? and again do u have bubbles in the coolant tank when the engine is running?, this is best checked when the engine is 1st started. I ask because I think u may have a leaking cylinder head gasket, this would account for the overheating still occurring.

You may have bad motor mounts. I would check this 1st.