I'm installing a new rear tail light with turn signal's and need the information/wiring diagram for the wiring diagram for the rear turn signals. The motorcycle is a 2002 Yamaha R6. You help would be appreciated. Thank you

Based on the wiring diagram in the service manual Red is License Plate Light & Tail Light, Gray is Rear Right Turn Signal Light, Blue/Red is Brake Light, Green is Rear Left Turn Signal, Black/Yellow is always Ground

Go to http://www.bbbind.com/free_tsb.html free wiring diagrams ! You having tail light problems ? Do you know how they work ?

They are turned on by the BCM !
Park, Tail, Marker and License Lamps
The park, tail, license, and marker lamps are turned ON when the headlamp switch is placed in either the HEAD or PARK lamp positions, or anytime the automatic light control (ALC) turns the headlamps ON. When the headlamp switch is placed in the park lamp or headlamp positions, ground from G202 is applied through the signal circuit to the BCM indicating the park lamp request. In response to this signal, the BCM applies ground through the park lamp relay control circuit energizing the PARK LP PCB Relay. With the relay energized, battery voltage is applied through the switch side of the relay, both park lamp fuses, and the supply voltage circuits illuminating the park, tail marker, and license lamps. Ground for the left front park and marker lamps is provided at G101 and the right front park and marker lamps at G100. Ground for all rear lamps is provided at G302.
Turn Signal Lamps
The LT T/SIG and RT T/SIG fuses located in the underhood fuse block supplies battery positive voltage to the body control module (BCM) for turn signal and hazard lamp operation. When the turn signal switch is place in either the LEFT or RIGHT position, ground from G202 is applied through the turn signal switch signal circuit to the BCM indicating the turn signal request. In response to this signal, the BCM applies a pulsating voltage to the front and rear turn signal lamps supply voltage circuits cycling the lamps ON and OFF. The BCM also sends a message via GMLAN to the instrument panel cluster (IPC) to cycle the turn signal indicator ON and OFF depending on the position of the turn signal switch.
Ground for the turn signal lamps is supplied as follows:
?€¢
G101 provides ground for the left front turn signal lamp

?€¢
G100 provides ground for the right front turn signal lamp

?€¢
G302 provides ground for the left and right rear turn signal lamps

With a test light check if you have power there with lights on and with lights off, compare left side with right side as far as location in the tail lamp plug for the tail lamp park lights.Trace the harness back to the left side underneath usual corrosion in this area.

Check the wiring, you might have the tail lights wired wrong or if you have led taillights installed they could be the culprit - you might have to install a new flasher designed to work with LED lights.

not jarred just crossed check wiring diagram again

need more ifo

Hi ! for a wire turn signals, please visit the website below. If you need more information about a specific electrical issue you can reach me at [email protected].
http://www.motorpartstore.com. good luck and have a nice day.

THE TAIL/MARKER LIGHTS, GO FROM THE HEADLIGHT SWITCH TO THE REAR FOR THE TAIL LIGHTS & TO THE FRONT FOR PARKING OR RUNNING LIGHTS. ALL THOSE LIGHTS ARE ON THE SAME CIRCUIT, { BROWN WIRE } THE BRAKE & TURN SIGNAL WIRES GO FROM THE STOP LIGHT SWITCH & FROM THE TURN SIGNAL/HAZARD SWITCH. NO RELAY IN THE TAIL/PARK CIRCUIT. CHECK THE FUSES WITH A GOOD FUSE TESTER.