Question about Suzuki GSX-R 1000 Motorcycles

1 Answer

Screaching noise from engine at 5000 rpm , almost like a loose fan belt noise but a little more rattly, if I accelorate or back of it goes away,also hear a spueking noise when bike is idling but it stops if i pull in the clutch..

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 31 Answers

Loose bolt holding the pressure plate on maybe

Posted on Aug 28, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 101 Answers

SOURCE: ZRX1100 P reg (1990?) Runs

Hi ...... Does noise 'go-away' if you pull in the clutch ? Could be a few things, cam chain needs adjustment or replacement (35,000 miles-ish), rotor on some Kawasakis made up of steel centre,alloy middle & steel outer. Parts can become loose, short term solution is to centre tap/spot sections but ultimately replace rotor. Have you ever had the left casing off ? Is there a gasket fitted or a thinner pattern type fitted ? When was the last time valve clearences checked/changed ? Did they change shims on that side ?
Let us know how you get on.

Posted on Jan 25, 2009

  • 4 Answers

SOURCE: noisey transmission when riding pull clutch in

Where the noise is coming from?

Head of engine?
Centre of engine?

Do you feel that your bike is riding heavy that is you are forwarding the gears but the load of engine is not lightning.

Please reply me then i will tell you the solution.

Posted on Mar 12, 2009

  • 298 Answers

SOURCE: idle problem when warmed up

Hi there!

On the carburetor, there is an idle knob. Make sure it is not set too high. This is normal during a cold start so make sure to adjust the idle knob back at 1,100 RPM after your engine is warmed up.

Also, make sure the choke system is clean and is free. Throttle cable should have an allowance of just about .8cm.

The engine idle may also be controlled with the thermostat connected to the grill fan. it will normally idle up to about 2,000 rpm when it senses that the engine is too hot but not 4,000.00 make sure this system is working well.

let me know if this helps
-levibit

Posted on Mar 29, 2009

  • 3 Answers

SOURCE: noise coming from clutch . goes away when clutch is

this sounds like it could possibly be a noisy thrust bearing in the gearbox itself

Posted on Apr 21, 2009

  • 420 Answers

SOURCE: noise in trans or in primary chain

It sounds like the primary drive chain is loose. The way I adjust mine is to take off the upper left inspection cover, start the bike and slowly tighten the adjuster until it starts to wine, then back off until it stops. Rev it slowly and listen for a wine. No wine good to go.

Posted on May 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The a/c light flashes when you turn on the heater blower motor. After awhile there's a screaching noise and it goes away if you change the engine rpm


The belt is slipping, hence the screeching noise as it puts a load on the alternator when turning on the blower. Adjust the belt tension tighter.

Sep 16, 2015 | Cars & Trucks

1 Answer

What causes a squeaky sound from the engine of an 2000 Isuzu rodeo when engine is running?


it could be one of the belts. if you put a little wax or brake fluid on the belt in a couple of places and the squeak goes away then you either have a loose belt/s or the belts/s need replacing. if no change it could be the timing belt making the noise.

Sep 14, 2014 | 2000 Isuzu Rodeo

1 Answer

Code p0301


could be loose alternator belt..if you can turn the alternator pulley by hand..its too loose..

Jan 08, 2014 | 2001 Honda CR-V

1 Answer

Have a 1995 ford heavy 250, 7.3 diesel, recently had fan belt replaced and now getting a loud high pitched vibration noise when accelerating it occurs between 1000 and 1500 Rpm and goes away at higher...


sounds like your fan clutch may be failing, remove the drive belt and manually spin all the pulleys by have listen for noise and feel for looseness in the bearings

Jul 31, 2011 | 1995 Ford F250

2 Answers

2004 Jeep Liberty makes high-pitched whistling noise when letting up on accelerator


with engine off check fan blades and shrould (plastic around fan) for cracks or if loose also check tailpipe bent at end if you backed into something. also check air filter box to make sure its tightly shut.

Apr 14, 2010 | 2004 Jeep Liberty

2 Answers

2009 Jeep Wrangler Unlimited low RPM Squeal


Could it be one of the belts is a little loose. Check it with the engine cold.
I hope this helps you.

Sep 22, 2009 | 2005 Jeep Wrangler

1 Answer

2001 Suzuki XL7 - engine has loud screaching noise when I start the engine, then it subsides after a minute or two. If I turn OFF the a/c before starting the engine, it doesn't make the noise. Where is the...


The blower is located under the passenger side however, the screech in the engine are is most likely a lose belt. Tighten or replace your belts and teh sound should go away.

Sep 14, 2009 | Suzuki XL7 Cars & Trucks

1 Answer

The car is a SC2 1996. There is a rattling noise


you can disconnect the drive belt and run the engine to find if it is external or internal . if the noise goes away with the drive ( Fan Belt) off , before replcing the belt spin all pullies with your hand .

Aug 29, 2009 | 1993 Saturn SC2

1 Answer

Rattling Coming from Engine At low RPM (stopped) and when accl.


If this sounds like a tin can rattle it is likely a loose heat shield on top of the catalytic converter. They come loose after time and corrosion take their toll.

Feb 25, 2009 | 2001 Lexus Gs 300

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

5926 Answers

ROB

Level 3 Expert

858 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...