Bike bogs for second then revs when throttling

Clean carb and air
mix screw needs set and rev screw

Have your carburator adjusted/calibrated/cleaned by a qualified service personnel.

Hi,,remove and clean the carb. before doing this you might want to check the air screw on the side of the carb, with the bike running turn the screw half a turn in and give the bike a rev,if it bogs more,turn the screw half a turn out and see if throttle response improves.

Hello,

This is a common problem depending on the area you live in.

Try this; quickly snap the throttle 3 -5 times and kick start it immediately. Do not open the throttle while trying to kick start your bike. You can open it about 1/4 of the way just before you kick start it, but let go of the throttle just as you kick start it - kick back sux and can hurt you.

You may have to run the bike a little richer (Carb adjustment).

Hope this helps. Please vote if this information was useful to you. Thanks!

Regards,

Oz

have u checked the float hight on the carburator? also make sure ur choke curcuit i clean and free of dirt

hi buddy set the needle clip to its normal condition and also on the carb is the mixture screw you need to turn this all the way in and out 1 turns and try this you will always get a bog if you rev fully too quick i had this problem with my kx85 and it was just this hope this helped mate i will send the pic in a mo

Quitting is a no-no. Move the needle clip down one notch and also remove and clean the carb if it has been dieing..

My 'wing won't run unless it has been warmed up some. I would suggest that you r&r your carbs to make sure the jets in the bottom are working correctly. They tend to get plugged up, especially after sitting & the aluminum flaking off inside... Rick