SOURCE: rich mixture virago xv250
http://www.stadiumyamaha.com/pages/parts/viewbybrand/2/Yamaha.aspx
look up your bike here and i think it is number 13 on the diagram. which looks like its right by where the throttle cable connects
SOURCE: looking for the air fuel mixture screws on carb any help?
[IMG]http://i199.photobucket.com/albums/aa59/88gixxer/100_4177.jpg[/IMG]
SOURCE: need to adjust my honda shadow 500 vt carburator's
start by synchronizing your throttle plates. Honda calls the next step the "idle drop procedure". u need to know if you have fuel adj. screws or air adj. screws. fuel screws will be on engine side of carb slide, air screws will be on airbox side of carb slide. start leaning out mixture, (turn in fuel screw, turn out air screw. idle will increase so keep adjusting idle back to spec.after each turn if needed. Adjust about 1/4 to 1/2 turn at a time on each carb until there is no change in idle, then richen up mixture by one half turn. If u sync throttle plates first then follow this procedure, there should be no hesitation when you "blip" the throttle, and after revving it should return to idle smooth,
SOURCE: air fuel mixture adjustment 04 honda 125 innova anf
the jetting should not be a problem, perhaps the air cleaner element is dirty or the element even if it looks ok sometimes needs a new one, the smaller motors often rely on the right intake vacumn through the filter for the carbs to work as designed
Testimonial: "yeah i did that and it made an instant difference.thanks again fixya. des obrien"
695 views
Usually answered in minutes!
×