Error code 0007 - 2011 Aprilia SR 50 R Factory

That error iddicate that the fixing film is worn out, and need to be replaced

1. -0007. Add toner. Meaning. An error has occurred in the. machine

I have exactly the same problem with my aprilia rs125 09 error 5 0007, do you solve this problem can you help me ???

I'm going to guess??? Do you have a Canon copier? If you do, the error code deals with the hard drive. You can try to do a F disk, it will only work for time enough to get to your car or out the door... You will need to replace the hard drive.... Good Luck

Error code 60 means the changing roller is not being detected position it properly. check if it is not in a pool of toner if so clean the toner properly with dry clothe.
Error 007 means the fixing fume is not being detected because it is damage and needs to be replaced.

I got an error code on my canon clc 1100:
E071 0007

Hi,

The "Ox18" series errors can be removed by resetting the printer. Unplug the USB cable from the printer, remove the ink cartridges. When the "Insert ink cartridges" message appears unplug the power cord from the printer. Wait 1 minute (at least), then reconnect the power cord and turn on the printer if it didn't come on by itself. Reinsert the ink, close the unit and print a calibration page if prompted to do so. Finally reconnect the USB cable to the printer. If this doesn't work, the unit needs service (or replacement if the service call will cost more than a new printer).

Thank you!!

do you need to clean the error in service mode tham do you have to restarted the machine,if it not soluve please send to me email and I we are going to see it ok.

On my CLC 1150 copier machine, I have an error code E071 – 0002.

Sir plz send soluation this error

This may well be a failure of the cutter switch sensor to reset. This worked for me.
Turn Off the Printer.
Remove both side panels and the plastic panel on the INSIDE of the DOOR on the right hand side. Then close the door and remove the plastic panel UNDER the door. This is held in place by two screws.

You will see a white gear on the bottom right hand side of the door. It is on the underside of the door. Turn this gear untill you can see the cutter move smoothly across the bottm of the door and return to the right side of the door. Listen for a click. This is the switch resetting. Close the door and power up the printer if you still get an error code 0008 or 0007 repeat the resetting process by turning the gear. BE SURE TO TURN OFF THE PRINTER!!