Axle assembly diagram exploded www - 2003 Yamaha YZ 125

http://www.ford-trucks.com/forums/871823-parts-diagram-front-axle.html try this website, about half way down the page there is an exploded view of axle. hope this helps

You failed to list what year and model bike you have. But, you can go to http://www.bikebandit.com and look at their exploded view drawings. This might help.

Good Luck
Steve

Go to the website below and you can see an exploded diagram of the assembly. Don't do the ' QUICK PARTS LOOK-UP ". Do the look-up below it. PLEASE rate my answer. Thanks.
www.babbittsonline.com

You didn't say if your bike is a 50cc or 1500cc. There is a bit of difference in the wheel mounting. In any event, go to the website below and you can see an exploded diagram of the Suzuki wheel assemblies. Do the " parts search by model ". Please rate my answer. Thanks!
www.babbittsonline.com

Halfshaft -sorry but the diagrams didn't paste into the fixya.com window, just the text. Also, this was for a 3.2L engine.
REMOVAL & INSTALLATION

1. Before servicing the vehicle, refer to the precautions in the beginning of
   this section.
   
2. Remove or disconnect the following:
   
   
   
   • Negative battery cable
     
   • Front wheel
     
   • Radiator skid plate
     
   • Transfer case skid plate
     
   • Brake calipers and mounting bracket
     
   • Brake rotor
     
   • Wheel speed sensor
     
   • Steering knuckle
   
   
3. Support the axle housing with a jack. Unbolt the axle mounting bracket and
   remove the halfshaft/bracket assembly.
   To install:
   
   
4. Install or connect the following:
   
   
   
   • Axle/bracket assembly. Tighten the bracket flange bolts to 85 ft. lbs. (116
     Nm) and the bracket mounting bolts to 112 ft. lbs. (152 Nm).
     
   • Steering knuckle
     
   • Wheel speed sensor
     
   • Brake rotor
     
   • Brake caliper and mounting bracket. Tighten the bracket bolts to 115 ft.
     lbs. (155 Nm).
     
   • Transfer case skid plate. Tighten the bolts to 27 ft. lbs. (37 Nm).
     
   • Radiator skid plate. Tighten the bolts to 58 ft. lbs. (78 Nm).
     
   • Front wheel
     
   • Negative battery cable
   
   
5. Check the wheel alignment and adjust as necessary.
   
   
   
   
   
   Fig. 1: Exploded view of the left halfshaft, axle shaft and
   axle disconnect
   
   
   
   
   
   
   
   Fig. 2: Exploded view of the right halfshaft and mounting
   bracket
   
   

I have a model to 30 tractor.The rear lugs to hold the tire rim need to be replaced,How hard is it to replace and do I take the
whole assembly apart to replace lugs

I don't know of any free downloads of that info, but if you don't mind paying $27 you can access exploded views of the axle components at alldatadiy website. The cost will allow you access to the site for that one vehicle for one year. You can print the info you want so you can bring the diagrams into the garage to work on it. This site is better than any repair manual I've ever seen. Recalls, time allowed for repairs, parts costs, everything about your vehicle you can imagine. Hope this helps.

Go to the site below where you can see a parts diagram for your specific bike. You will select the actual brand, year, model, etc., once you go to the site. Part numbers and prices are also shown. You can order parts from this site. Your specific bike is there. I would copy and paste but the image is copyrighted.
www.babbittsonline.com/pages/parts/viewbybrandand/parts.aspx
Could you take a moment and rate my answer? Thanks!

Hi! Here you go!! hope this helps you!