Ignition 1972-73 yamaha enduro dt2 or dt3 eng 250, . removed wiring harness, lights turnsignals ect, i want to ride just on dirt, the wires coming out of the magneto (5 of them) green/red, green, black, yellow and white. i want to run just the coil, how do i configure those wires, has no electronic components in wiring, i tested the leads from the magneto and not regestering any voltage, how do i configure the wiring just for the coil, thank you very much!

check the ignition fuse its blown. put a new one and it wil start

could be the wiring in australia they came with an extra loom to run the bike with out a key ignition switch, the previous owner may have changed them and not changed them back

with Steering lock on headstock and correct tank using the plug in black connector Bosch ignition - she looks great and pulls like a train.... My problem is that I am entered into an Enduro in France (I am in England) on the 14th October and the bike must have working lights.....It has a headlight and Tail light but no wiring connecting them. There are several spare wires taped up under the tank I am quite happy to carry out the wiring I just need to know the colours to use...and how to check them I have a multimeter available. It has a horn attached and I have bought a high/low /horn switch , as well as a rear brake light switch...,I have written this motoplat instruction quite a while back: http://www.ktm495.mxbikes.com/motoplat.htm Right at the bottom is the color coding for the lightning wires.,,,