Buy oil, oil filter and spark plugs from any auto parts store. Let your bike warm up before draining oil. On the bottom is the oil drain plug. Remove plug and let drain. While draining remove old oil filter. Let it sit for about 10 min to make sure all oil has been drained. Replace plug, apply small amount of oil to filter seal (just run your finger around the seal with oil on it) and tighten. You will need any type of oil filter wrench to tighten up filter. If it doesn't leak it's tight enough. I got a wrench this year for $2 at ace hardware. Then fill with oil. Go by your manual on how much oil your bike recommends. Should be around 3.3 quarts. Once you add the oil and put the cap on, crank your bike and let it run for 30sec-1min. Turn off. Pull out oil dipstick and wipe it off. With bike level place dipstick back and then remove. Oil should be between the 2 lines. Closer to the top line the better but NOT OVER THE LINE. If no dipstick you may have a clear window on the case to see the oil and the fill line. Spark plugs just remove wires (takes a little force) then just use a spark plug socket and remove them. Best is one at a time so you do not cross any plug wires. When installing the new ones HAND TIGHTHEN FIRST. Once you have done that use socket to tighten VERY LITTLE. 1/8 inch once seated. Do not over tighten. Then reapply plug wires. Hope this helps.
138 views
Usually answered in minutes!
×