How much and what type of oil do I need in the gearbox?
Also what is the recomended pre-mix ratio?
Hi,
The bike uses around 600ml of gear oil, but you should always check the level at the level bolt. When the bolt is removed, fill oil until it flows out the level hole. Replace bolt. Run the motor briefly and then inspect the level again. Add more oil if needed. Use BelRay trans oil 10w80.
The fuel mix should be 3.5 percent oil to unleaded fuel.
If you are not racing, mix 30:1
Always use a good fully synthetic oil
Jon
1,048 views
Usually answered in minutes!
×