Putting on new front brake lines.
SOURCE: brake light
front brake lever not depressing brake light button. inside throttle housing or I had a guy the other day thought brake light was stuck on (found burnt fillament brake light)
SOURCE: Will the wheels from a 2000 Harley-Davidson FXDX
Check to see if they both have the same diameter axle. Harley went from a 7/8 inch diameter axle to a 1 inch diameter axle sometime around that time period.
SOURCE: I just purchased a 2008 Street Glide and the brake
Make sure the brake master cylinder is positioned firmly back against the switch housing. Loosen the two bolts that hold the master cylinder onto the handlebars and slide it back against the switch as firmly as possible. If this does not correct the problem, you must replace the front brake switch inside the throttle/switch housing.
SOURCE: need to replace rear brakes on 2008 street glide
it's pretty straight forward. remove saddle bag, remove the 2 allen bolts that hold the caliper to bracket slide caliper up off of disc. then remove the small 3/16 allen bolt this is the pad pin that hold the pad. before you remove the pads turn caliper upside down and with a large screwdriver put it betweenthe old pads and trist it to push the piston back in the caliper this will give you room for the new pads. then just lift the old pads out and put in the new and reinstall the pad pin and caliper back on bracket install the 2 bolts removed first and tighten good. if you need any more help just ask.
SOURCE: 2006 Harley Davidson street glide brake light
Try loosening the bolts holding the front master cylinder on the handlebars. Slide the master cylinder down as close as possible to the right handlebar switch housing. If this doesn't work, the front brake light switch is probably bad and needs to be replaced in the right switch housing.
Good luck
Steve
224 views
Usually answered in minutes!
×