I would just like to be able to change the oil myself instead of someone else doing it.
1) Purchase appropriate oil filter, sump drain bung washer and chosen engine oil.
2) Prepare an oil pan, sump bung wrench and oil filter removal tool (check access to oil filter to be sure that your tool is suitable.)
3) Run the engine until its warm to hot.
4) With the car jacked up and secured, remove engine oil filler cap and remove engine oil sump drain bung and allow oil to flow out into your drain pan. Keep an eye on your oil and make sure it doesn't overflow from your drain pan.
5) Refit sump bung with new washer and tighten. Do not over-tighten, and be especially careful when tightening into an alluminium sump.
6) Remove oil filter. Oil will flow out from this filter when removing, so your drain pan will need to be under the filter housing when removing.
7) Run a smear of clean engine oil around the filter rubber seal and refit new filter. Tighten hand tight only. Do NOT crank this filter super tight as you may damage the rubber seal and even the filter casing which can impede oil flow.
8) Refill engine with proper quantity of oil. If you cannot find how much oil your engine is supposed to take, then refill with the same quantity of oil which you drained out.
9) Restart the engine while checking the oil pressure warning light on the dash. The warning light may stay on for three or four seconds and then go out. If this light stays on for longer, then stop your engine and check for oil leaks at the filter body and sump drain bung.
10) Once the engine oil pressure warning light is off after starting, stop the engine and check the engine oil level (with vehicle on the flat and off any axle stands.)
11) Road test the vehicle, driving it for a mile or two before re-checking for oil leaks under the engine bay and engine oil quantity.
SOURCE: THERMOSTAT OUT ON 1994 LINCOLN TOWN CR
go to a shop, or try buying a new one, then open your hood and change it.
SOURCE: changing spark plugs on lincoln town car
Remove the spark plug wires, remove the spark plugs,replace them. Do this one cylinder at a time if you never did it. On that year you may need to remove the upper intake to access the plugs on one side. In that case go to a shop. This would not be a novice job.
SOURCE: how to reset the change oil light for lincoln town
Press setup on message center,
press select for system check,
At oil life, press reset
SOURCE: How do you change the door hinge pin? On 1997 lincoln town car?
you really don't change the pin,...change the whole hinge,...junkyard! junkyard! good luck, cracklin joe
SOURCE: How to reset the change oil light for a 2007
FIRST press and release the setup button to display oil life= xxx
then press and hold the reset button for about 2 sec it should then display oil life set to 100%
--------------------------------
Just pressing the reset button when the change oil light comes on while driving will not reset the computer
274 views
Usually answered in minutes!
×