How do I change the clutch master cylinder on a 1996 Honda Shadow Spirit 1100
SOURCE: 2005 honda shadow spirit 1100. runs with choke on
Have you tried to adjust the tickover screw on the carbs?
SOURCE: Do I use regular or premium gas for my '96 Honda VT 1100 C Shadow
You always want to use the highest octane gas u can find in a motorcycle engine .... 91 at least
SOURCE: 84 honda shadow vt700 clutch slips when hot
Your clutch plates have lasted 25 years. It is probably time to get some new plates. Have your dealer get you a set of Barnett clutch plates.
SOURCE: stator removal honda
There is a tool that is used, it looks like a steering wheel puller or flywheel puller. Loosen the nut, a strap tool is handing to hold the stator still while you loosen the nut. Then using the removal tool, you pull this off. reassemble by tighting the nut. You should be able to get a puller at autozone in the loan a tool program. I hope this helps
SOURCE: 2000 honda 1100 shadow spirit. Rough idle, little power.
Replace the spark plug caps and try again. On Honda's the cap is often part of the wire (a dealer part) NGK makes some inexpensive plug caps about $5 each. They should OHM out to 5000 anything above or below and you need to replace them. This should fix the problem.
209 views
Usually answered in minutes!
FirstĀ are you sure it's the MAster cylinder, at the handle bars and not the slave cylinder down by the engineĀ that is causing your problem?
I have replaced the slave cylinder down by the engine, I also just rebuilt the clutch on the handle bars with a rebuild
continued, nothing is working, what do I do? FRUSTRATED!!!
×