Question about 2005 Suzuki GSX-R 1000

1 Answer

2005 Suzuki GSX-R 1000 engine boggs at 6000 rpm and at wide open throttle

Engine bog @

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Suzuki Master
  • 57,613 Answers

Hi, Anonymous engine "BOG" is mainly caused by a rich air and lean fuel condition but it can also be caused by a lean air and rich fuel condition this situation rarely occurs and is only caused by the misinformed weekend warrior that owns a toolbox. If the bike has been sitting for months or years you will have to completely disassemble the carburetor and submerge the parts (except rubber parts) in "Carburetor Dip" It usually comes in a gallon bucket with a wire mesh basket that can be purchased at any automotive store. If it is not the above scenario then the following explanation will apply.
The more you open your throttle the more vacuum you are creating in your carburetor venturi and your intake manifold. When you are operating at higher RPM any unmetered air that leaks into your system can become more obvious.
Unmetered air is air that is getting into your system after the fuel has been delivered. If you have unmetered air getting into your system between the butterfly/slide of the carburetor and the cylinder head this will create a lean condition.
All of the rubber components of the fuel system like vacuum hoses and intake manifold that you mount the carburetor to are made of rubber. If none of these components have been changed they are more than likely highly degraded and probably cracked in places to allow unwanted-unmetered-contaminated air into the combustion chamber. Check all of your vacuum lines and vacuum plugs for carburetor synchronization. The vacuum plugs are in the head just after the rubber intake manifolds. The petcock has a vacuum line as well as part of the emission system.
1. Check the intake manifold for fissures.
2. Ensure the bands used to tighten the manifolds down on the intake are secure and have not bound up the manifold.
3. Make sure air box fittings are not warped and fit completely over the carburetor.
4. For 2 strokes make sure the power valve is adjusted properly.
Your airbox is metering air and is the first step in a process of consuming air and fuel. The system requires the resistance of the air filter in order to get the proper vacuum to "SUCK" the fuel out of the float bowl and create the proper venturi effect.
Improper mounting and sealing of the airbox will create a small lean effect. This might seem like no big deal but you are inviting dust and debris in your engine that is doing slow damage by not having proper fitment. Fix it so you know it's not contributing to your issue. Pick the low-hanging fruit first.
Do not go and start adjusting anything at this point. It ran fine before. There is something wrong with the assembly or a component. Do not adjust your floats. Get it back to where it was. The moment you start tweaking everything is the moment you lose OEM settings which are a must-have for fine-tuning and maximum performance.
Fine-tuning your carburetor and multi carb syncing come at the very end following the proper procedure established by the Carburetor Gods.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Bogging down when full throttle GSXR com 2000 gsxr 750 bogging Suzuki GSX R1000 Service Manual https://www.partsfish.com/page/oem-parts-for-suzuki http://mybikemanuals.com/suzuki/suzuki-gsx-owners-manuals

Posted on Oct 29, 2018

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 311 Answers

SOURCE: i have a 2008 Suzuki GSX-R 1000 an it boggs out at

if the bike is unmodified and is fuel injected,there may be a fault in the ecu programme and probably the best solution to find the fault would be a trip to someone wioth a scan tool,they should be able to find the fault in minutes...cheeers

Posted on Jul 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bike dies at 6000 rpm


Sounds like clogged or partialy clogged main jets.

Aug 04, 2017 | 2005 Suzuki GSX-R 600

1 Answer

My hayabusa 2002 RPM sudden drop then back to normal you know why?


we do not ,freaky problems need to be observed when they happen which we can not do

Dec 04, 2017 | 2002 Suzuki GSX 1300 R Hayabusa

1 Answer

1991 Suzuki GSX 600 F (Katana) will not idle


Hi, Kenny and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
13. Faulty auto choke or wiring connection.
For more information about your issue and valuable "Free" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Idle problem with my GSX 600F Suzuki GSX Motorcycle Forums Gixxer com http://forums.cycleworld.com/archive/index.php/t-131716.html Suzuki GSX600 Katana 1989 1997 Workshop Service Repair Manua Download... $15 https://www.partsfish.com/oem-parts-for-suzuki http://mybikemanuals.com/suzuki/suzuki-gsx-owners-manuals

Aug 21, 2012 | 1991 Suzuki GSX 600 F (Katana)

1 Answer

Katana carb diagnostics


Hi, Anonymous and the usual suspects are:
1. Extremely lean fuel mixture.
2. Dirt, rust, water, or ethanol sludge in the fuel system.
3. Sticky throttle cables.
4. Multiple carburetors not in synchronization.
5. TPS sensor out of adjustment or faulty.
6. Wrong spark plugs for the type of service.
7. Throttle bodies not in synchronization (FI)
8. Faulty O2 sensor.
9. Clogged, stuck, or faulty IAC valve.
10. Aftermarket components not compatible with ECM.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Idle problem with my GSX 600F Suzuki GSX Motorcycle Forums Gixxer com
Throttle position sensor fix GSXR 750
Suzuki 85 GSX R750 Service Repair Manual
OEM parts for Suzuki
http://mybikemanuals.com/suzuki/suzuki-gsx-owners-manuals

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Apr 18, 2017 | 2001 Suzuki GSX 600 F (Katana)

1 Answer

My 2005 Katana 600 F was idling slow at about 600 - 700 RPM so I messed with a throttle screw under the throttle lever. I got it to idle at 1000 RPM where I think it should be. But now when I turn the...


turn the cable adjuster back to its original position ie between 600-700 rpm look to the left hand side of the carbs you will see a large adjusting screw on a metal bracket whilst engine is running turn inwards towards rear wheel until between 1000 - 1500 rpm remember to warm engine first as rpm will rise if idle is set with a cold engine as the engine warms up when riding

Aug 09, 2010 | 2005 Suzuki GSX 600 F (Katana)

1 Answer

I have a 2008 Suzuki GSX-R 1000 an it boggs out at arround 2600 and 3000 rpm i don't know why


if the bike is unmodified and is fuel injected,there may be a fault in the ecu programme and probably the best solution to find the fault would be a trip to someone wioth a scan tool,they should be able to find the fault in minutes...cheeers

Jul 03, 2009 | 2007 Suzuki GSX-R 1000

1 Answer

Rpm problem


check that your air filter and intake tubes are clear

Jun 27, 2009 | 2001 Suzuki GSX-R 1000

2 Answers

Boggs


does it smell of fuel once this happens? initial thought is the carburetor's not set up right.

Jun 12, 2009 | 1996 Suzuki GSX-R 750 T

1 Answer

Motor bogs when you give it gas


It is a fuel problem, it can be filter or rubber membrane,they are placed in the valve for fuel.
lp

Mar 20, 2009 | 1984 Honda VT 500 C Shadow

Not finding what you are looking for?
2005 Suzuki GSX-R 1000 Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

5924 Answers

richard libby

Level 2 Expert

209 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...