Gas tank removal 1993 k1100lt

you can pull the tank off, and put new straps on after. or cut a hole in the trunk just above where your fule pump is and remove the pump that way, patch floor afterwards

in-tank fuel pump. remove gas tank and remove the fuel pump and screen from it and either clean the pump and screen(or in-tank filter) or replace it with a new one. Its a lot easier if you empty the tank first.

First take the trip meter reset knob off the speedometer. Then remove the center bolt or nut from the middle of the console just below the speedometer. Work the console cover off of the speedometer. Remove the seat. Remove the fuel line from the fuel petcock and drain as much fuel out of the tank as you can. Once you get as much fuel from the petcock, disconnect the "cross-over" fuel line at the front of the tank. Catch as much of the gasoline as possible.

Remove the two bolts at the Front of each tank and the one at the rear of the tank on top of the frame remove the tanks one at the time. There is a vent line that connects both tanks that crosses underneath the dash.

You have to remove the gas tank .First lossen the gas cap to remove the pressure. the fuel pump is inside the tank. The tank has two bands that are bolted in place . Siphon out the gas from the tank. The tank will come down . remove the wiring plug from the tank. You can now remove the ring surrounding the fuel pump. Take off the old pump and replace it with the new one. be sure to notice how you took off the electronic plug. reinstall it. Replace the tank and refill it with gas. it should work . you may have to work the fuel pump around to install it.

remove gas tank straps and make sure to unplug the fuel pump harness and remove filler tube from tank it is usually screwed down where you put gas in to fill it up

the fuel pump is in the gas tank and there maybe an access port under the back seat if not you have to remove the tank from under the car

hello. it should be located under your car on a line that's coming off your fuel tank and yes you can do this your self very easy to do ,you'll need a few box/open ended wrenches that's it you'll need to check the fitting or the nut on each side of the filter to see what the sizes are,befor removing the filter you'll want to take off your gas cap and remove your neg battery cable ,not when you find the filter it'll have nut on each side all you have to do it loosen them but make sure that you don't break the fuel line or kink it and after you have both sides loose then just finish turning them off and there you go the filter is off, nope no removing the gas tank some newer models you do and the filter is attached to your fuel pump and don't need replaced but for your car and year you wont need to remove the tank. good luck

You will have to remove your back seat to gain access to fuel pump. Fuel tank is located in trunk. No need to take fuel tank down.

1. Drain the fuel from the fuel tank.
2. Properly relieve the fuel system pressure.
3. Remove the fuel pump access plate beneath the rear seat.
4. Label and disconnect the fuel hoses and electrical harness.
5. Raise and safely support the rear of the vehicle.
6. Label all fuel lines for installation reference.
7. On 240SX models, remove the exhaust center tube, driveshaft, differential carrier and rear suspension member.
8. Disconnect the fuel filler hose and vent hose.
9. Remove the fuel tank protector assembly.
10. Remove the fuel tank band retaining bolts while supporting the fuel tank with a transmission jack.
11. Slowly lower the tank assembly from the vehicle.

To install:

1. Position the tank assembly on the vehicle.
2. Install the fuel tank retaining bands and tighten the bolts to 20-27 ft. lbs. (26-36 Nm).
3. Install the fuel tank protector assembly.
4. Connect the fuel filler hose and vent hose. Tighten the hose clamps securely.
5. On 240SX models, install the exhaust center tube, driveshaft, differential carrier and rear suspension member.
6. Lower the rear of the vehicle.
7. Connect the fuel hoses and electrical harness.
8. Install the fuel pump access plate beneath the rear seat.
9. Fill the fuel tank with a few gallons of fresh fuel.
10. Pressurize the fuel system and check for leaks.

I hope this helps... If the exhaust as been changed or modified it might be necessary to loosen.

in the gas tank on top of it. If u remove tank, try and do so when it's as empty as possible. Be careful as the metal straps retaining the gas tank in place are most probably pretty rusted and they have a good chance of breaking when u try to remove them.