You need to be doing over 10 mph to select anything other than 1st...if it will not change up while riding then I would suspect that the bearings that stop the other gears engaging at low speed are stuck or worn. This system is designed to make it easier to find neutral at a standstill. If you haven't tried to change gear while moving get someone to spin the back wheel as you change up and the problem should go away...
Testimonial: "thanks will check this out"
SOURCE: can i fix dented frame? where to find cheap parts?
If the dent is only a dent, yes you can fix it with body putty and paint. If the "dent" is really a bend that has put the frame out of alignment then, no you can't fix it > not properly anyway. It may be possible for a frame shop to straighten but you can probably get a good used frame for the same money.
Google " motorcycle salvage kawasaki ". You can probably find a frame there.
Please take a moment and rate this solution. Thanks djukome!
SOURCE: need to remove the cam chain on my kawasaki zx6r
Cam chain replacement is a bit complex for a beginner. I don't recommend it. However, I would suggest the best way is to have a service manual at hand. Go to this site and you can download a free PDF service manual.www.carlsalter.com/motorcycle-manuals.asp
The 2005 manual (4th from the bottom), is 11MB. You can go with the '05 manual as the service proceedure is the same as the 1998. The 2002 manual is 80 MB (scanned differently).
Go to the site below where you can see a parts diagram for your specific bike. You will select the actual brand, year, model, etc., once you go to the site. Part numbers and prices are also shown. You can order parts from this site. In the event no price is shown on a particular part and/or the notation "Not Available" is in the description, the part is not in stock. www.babbittsonline.com/pages/parts/viewbybrandand/parts.aspx
Can I get a “very helpful” rating on this answer?
SOURCE: Oil capacity for Kawasaki 1997 ZX6R?
Depends if the oil and filter and oil cooler have been dismantled. If not and only the old oil has been drained it should be approx 4lr's, should state this under the oil filler as a guide. If its a complete strip down and rebuild your'll need at least 4.5ltr - 5ltr's so put in 4.5 and run for 5 mins, then check level
SOURCE: seriously overheating zx6r ninja
my bike did the same thing, and it sounds to me like your riding in a lower gear and your thermostat sensor on the radiator needs to be replaced
SOURCE: where is the engine number
your engine is located behind the faring and below the fuel tank.Thank you.
247 views
Usually answered in minutes!
×