Nowadays im finding shakes at the handbar of my splendour2003

THAT IS A BAD SIGN
AND IS A HANDS ON check
any time brakes do that, its a huge SIGN OF DANGER To you and others.
get off the internet and find hands on, help.

mcdevito75 here, Sounds like your Guess watch neds some service, cleaning, oil etc. You can check with the repairservice directory right here at fixya, bottom of this page click on repair service directory then watches.

A misfire can be caused by a bad spark plug, wire, or coil, or bad timing, or not enough gas or bad idle mixture.

The symptom is common on cars that have bad compression in a cylinder, as well.

Good luck on this repair.

The usual cause for this is because the brake rotors on your Stratus have warped slightly. In the old days, it was easy enough to simply change the brake pads and then have the rotors "turned" (machined) so they turn true. Nowadays, finding a place to have your rotors machined isn't all that easy, though you may just get lucky. It's usually around $10/rotor. Replacing the rotors sometimes seems to be the only option. You'll be able to find them at Advance Auto Parts, Auto Zone, etc., and usually run around $30/each. Of course, while you have the brake calipers removed to remove the rotors, you may want to go ahead and put a new set of brake pads on there as well. You'll notice an immediate difference in braking once you get back on the road, without all that incessive shaking to a stop!

I hope this helps! :)

i have both the double and single dreamer design stroller and on both - there is a black pull thingie ... if you put your hands on the handbar and then follow down the frame (along the back side of the seat). You will feel it - as it is kinda hard to see. Once you pull this on both sides, push down on the handbar - towards the ground. The stroller will then fold down and in half.

hmm.. im just taking a shot in the dark but when my car did this i needed new wheel bushings. It would shake and sound louder than usual.. not crazy, but a little louder. Anyhow, I changed my bushings and the shake was gone! :) justa suggestion..

Friend,
ngfam1 At your service!

The washer should be leveled with a spirit level.

If it is not corrected after this measure!
remember you have a full warranty for one year and they will come out a remedy the problem with hands on service! for FREE!

Then here is a good company that's found nation wide.
A&E Factory Service
A&E has schedulers available to take appointments 24/7
And they do warranty work too, for most manufactures!
1(800) 905-9505

You will be fine
Bless You ngafm1
PLEASE GIVE ME A GOOD RATING BEFORE YOU SIGN OF