It is located on the oil pan, please be advised the oil pan is also the casting that houses the front differential, and the engine oil drain is the hex nut furthest to the rear of of the pan . You will need a 17mm wrench to remove the hex nut . After you drain the oil, DO NOT over tighten the plug . The proper torque is 25 newton/meters or about 20 foot/pounds
SOURCE: For 2002 BMW 325I a yellow oil light comes on when
The oil light does not show that you need oil necessarily. The oil light goes on when the oil pressure is low, not the oil, so it could be a problem with your oil pump or otherwise. Common that it would go on and off, it it were to stay on for very long you'd lose oil pressure and could be in trouble. Have it looked at.
Good luck!
EJ
SOURCE: check engine light comes on but car runs great 2002 bmw 325i and
The check engine light could be any number of things and the only way to find out is have the codes scanned. The brake light issue is common on E46 3 series. It is an issue were the brown ground wire that goes into the lamp housing melts at the connector causing a loose ground connection. The connector needs to be replaced and also add additional grounding wires to prevent further issues. And for fuel additives either use the cheveron techron, or the bmw fuel additive(the bmw stuff is the exact same thing, so just use which ever is cheaper).
SOURCE: Change clock on 2002 BMW 325i
hello jsosa, if I remember correctly, you need to turn and hold the right button on the instrument cluster. the button only turns a little and has a detent.
SOURCE: for 2002 BMW 325i.
WHILE HOLDING LEFT ODOMETER RESET BUTTON TURN KEY TO POSITION 1, HOLD FOR 5 SECONDS , SIGN STATING OIL- INSPECTION RESET, ETC SHOULD APPEAR , LET GO AND HOLD AGAIN, A SIGN WILL FLASH, PRESS THE BUTTON THIS TIME.
I T BELIEVE IT WILL WORK OUT.
SOURCE: 2001 bmw 325i changing spark plugs
it doesant sound like its a problem from your spark plugs sounds more like a stepper motor problem make sure you have fitted everthing correctly after you have changed spark plugs sensors ect if you needed to remove elctrical sensors
308 views
Usually answered in minutes!
×