SOURCE: 1998 harley davidson softail custom primary cover bolt pattern
Are u asking for the torque sequence for the outer primary cover ?
SOURCE: how to change brake pads on a 2005 1200 Harley
there is 2 bolts on the caliper take them off and there are pad pins that need to be taken out.. inside the caliper there is a metal clip where the pad sits in.. put them in the same way they came out once you start its pretty self explainatory.. you should not have to blead them
SOURCE: HOW TO CHANGE REAR BRAKE LIGHT SWITCH ON A HARLEY
To change the switch, first unplug the wires at the switch. Screw the old switch out and install the new switch into the tee connector. Do not depress either brake lever while the switch is out. Tighten the switch and reconnect the wires.
Usually you don't have to bleed any air out of the brake system but check the rear brakes for proper operaion. If the rear brake pedal goes too far down, bleed the brakes at the rear caliper. Make sure you don't run the rear brake master cylinder dry while bleeding the rear brake. Use only the approved type of brake fluid, do not mix the different types of fluid. Make sure the rear brakes are working properly before riding the bike.
SOURCE: Where is the rear brake light switch located on a
Follow the brake line from the rear of the rear brake master cylinder until you get to a round metal thing with two wires attached to it screwed into a Tee fitting. This is the rear brake light switch.
SOURCE: Directions from start to finish
http://www.jpcycles.com/product/380-879
Jp has the harness and easy to follow instructions, if you already have
the harness, and the old one is still on the bike. you could strip down
and tag each wire before pulling harness . use old harness to apply
new harness , everything will be the same. some connections may
need to be added, but this is minor .
1,057 views
Usually answered in minutes!
×