I have 2006 ford taurus se and windshield wiper relay needs to be replaced, where is this located, could a picture be attached showing location?

SOURCE: What relays are there for the intermittent wipers

the intermitent works off of the (gem) generic electronic module which controls the wipers. if wipers working except the delay cycle replace the module. the relays are located in the engine compartment . wiper park relay- wiper hi-lo relay- washer motor relay. fuse in fuse panel under driver side dash panel.

michael schultz

• 1068 Answers
• Posted on Oct 21, 2009

SOURCE: where is the windshield wiper relay module located

there are two relays for the wiper run park relay and high / low relay they are located in the battery junction box under the hood and they are on the left side middle above the rows of fuses.

let me know if you have any more question.

SOURCE: 97 ford taurus

under hood left side firewall

Greg Bernett

• 2993 Answers
• Posted on Oct 01, 2009

SOURCE: Ford Taurus 1999SE-Windshield wiper motor just hums.How to fix ?

Removal & Installation To Remove:

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Disconnect the battery ground cable.
3. Remove the wiper arms.
4. Remove the 8 plastic retainers and the 6 clips holding the cowl vent screens to the inner panels. Turn the retainers 1⁄4 turn counterclockwise to remove.
5. Remove the cowl vent screens.
6. Disconnect the electrical connector from the wiper motor and remove the 4 bolts that mount the module assembly to the cowl.
7. Remove the windshield wiper module from the vehicle.
8. Rotate the wiper operating arm in a clockwise direction to gain access to the bolt retaining the arm to the motor. WARNING
   Always rotate the wiper operating arm in a clockwise motion or damage to the motor could occur.
   
9. Remove the nut retaining the wiper operating arm to the wiper motor.
10. Remove the three wiper motor-to-wiper module assembly retaining bolts and remove the motor from the vehicle.

1. Position the wiper motor on to the module assembly. Install the three wiper motor-to-wiper module assembly retaining bolts. Tighten the bolts to 115-151 in lbs (13-17 Nm).
2. Position the wiper operating arm on the wiper motor output shaft. Install the mounting nut and tighten to 22-29 ft-lbs (30-40 Nm).
3. Position the windshield wiper module onto the cowl. Install the mounting bolts and tighten to 106 in-lbs (12 Nm).
4. Connect the wiper motor electrical connector.
5. Position the cowl vent screens onto the inner panels. Install the 8 plastic retainers and the 6 clips holding the cowl vent screens to the inner panels. Turn the retainers 1⁄4 turn counterclockwise to install.
6. Install the wiper arms.
7. Connect the battery ground cable.
8. Adjust wiper arms if necessary.

Testimonial: "Fast and accurate response."

SOURCE: brake light switch

brake light swihch behind brake pedal there are one or two bolts holding it un plug it