Transmission oil change in 2000 Harley Davidson fxst

SOURCE: where is the drain plud located on a 2003 fxst

bottom of frame under oil tank

SOURCE: want to do engine oil tank drain ,but can't seam

On most softail bikes, the "horseshoe" oil tank has a drain mounted down low on the frame. Look along the bottom side of the oil tank from the right side of the bike. You'll see a hose or a pipe going downwards towards the transmission. The rest of the pipes run to the engine. Follow this on down and it should run along the frame just behind and below the transmission. It'll have a plug in the end of the hose or pipe. Remove the plug and the engine oil will drain out.

Hope this helps
Steve

SOURCE: oil change procedure 2000 road king

the oil tank is on the bottom of the transmission in your RK. There are two drain plugs. The plug towards the front left of the pan is the oil drain plug. The other one is for the transmission.

Drain the oil, replace the filter, refill with three quarts of oil and you're ready to go. The dipstick has two marks on it. The upper mark is "FULL HOT", and the lower mark is "FULL COLD". Do not overfill.

Don't forget to service the transmission and the primary at their recommended intervals.

Good Luck
steve

SOURCE: how to change engine oil on a 2000 harley davidson

On the right hand side of the bike, look under the bottom of the oil tank. You should see a large hose or pipe running from the bottom of the tank down behind the transmission. It follows the frame down low behind the exhaust system. Now, Harley changed the location of the plug and I don't know what year they did it. The plug will be a metal plug stuck into the end of the hose or it will be a screw in plug under the frame in the cross brace. Just follow the large hose to the end and you'll find the plug.

Good Luck
Steve

SOURCE: How do I replace the

Remove: front fender,wheel,caliper(s).windshield/fairing
Loosen pinch bolts. Remove downtubes . remember which one goes where
Remove seals ans install new ones
Since you are that close: remove the tripple trees and grease the steering head bearings.