How to replace ignition switch on harley davidson 2002 dyna low rider?

Duplicate question already answered

bad switch

Check your ignition fuse first,

it could be a fuse or a break in the cable ,check with a multi meter from battery to the switch and all the connecters cheers

1. Remove seat.

1WARNING

To avoid accidental start-up of vehicle and possible personal

injury, disconnect the battery cables before proceeding.

Inadequate safety precautions could result in

death or serious injury.

WARNING

Always disconnect the negative cable first. If the positive cable should contact ground with the negative cable installed, the resulting sparks may cause a battery explosion which could result in death or serious injury.

2. Disconnect battery cables, negative cable first.

3. Unscrew ignition/light lock ring. Push switch back through hole.

4. Cut switch wires approximately 3.0 in. (76 mm) from switch body. The new switch must be spliced into existing wiring harness using splice connectors.

5. After splicing new switch into wire harness, place switch into position. The word "TOP" is marked on the top of the switch body to allow for proper positioning of switch.

6. Install lock ring to secure switch in place.

simply put yes. When you reinstall you will use the jam nut to lock the mirror in place.