I have a 2011 Yamaha fz8n with a clutch problem when i go to but the bike into first the bike jerks and stalls i have try ed adjusting a the lever but still dose it help
SOURCE: 1100 wierd clutch disengage problem
Bleed your slave cylinder on the sprocket cover and refill the hydraulic fluid. If you have any leaks you will get air in the system and it will not fully disengage the clutch. As for the 750, they have cable clutches and you just need to adjust the slack of the cable.
SOURCE: '95 Yamaha YZ 125 clutch - stays in gear when clutch is pulled in
hey dude,, just thought id come in and give u some tips or 3,, i take it when u pull clutch lever in, and try and change gear it feels like your foot will snap b4 it goes in gear,, if that makes sense,, firstly mate,is to make sure the clutch cable slides freely ,easest way is to take cable off and just grab 1 end and make sure it isnt sticky,, if so dip one end of the cable in a bit of old oil ,,whilst holdin the other end ,pull and push the cable inner, this will **** up a bit of lubricant inside the cable ,, keep doin this each end till free to move, ,,next step if the cables ok,,, and may need help if u dont no,drain the oil out,,and as u r sat on the bike is to remove the clutch casing on the right hand side of the moter,where the bottom end of the cable goes,remove the casing being carefull not damage the gasket,,then u will see clutch plates and friction plates housed,, undo the 7 or 8 spring loaded bolts carefully take the first fibre plate out then metal friction plate then another fibre plate and so on,, wen u take the 1st plate out place that on the bench ,stacking each plate on top of one another, cause they have to go back in as they came out,,wen out,,u need a piece of wet n dry paper ,or fine emery,,and just wipe round both sides of the fibre plates taking the shine off them,as u put them back in,, put casing back on with a decent gasket,, oil back in cable on, make sure cable has no free play on the lever so wen u r about to pull lever in it bite straight away,, start her up, warm it up and try it,,any probs still il eat my shoe,, take care m8
SOURCE: 2003 KX125 Clutch Problem
have you checked the basket for groves? if it is groved the plates will stick the release all of a sudden.
SOURCE: clutch snatching Madass 125cc
Could be burnt, or scorched clutch discs. DId you check the oil lately? I believe the Madasses have a wet clutch, right? Hope you didn't burn up the whole clutch basket. But you may have. Check the oil now!!!
SOURCE: I had a recall on my 2008 CBR 1000. I had the
take off the clutch insp plate loosen the locking nut adjust the rod back then full on then back one eighth of a turn..
179 views
Usually answered in minutes!
×