2000 suzuki marauder vz800
Changing rings in head need to know the foot pound pressure on 14mm head bolt and on 10mm head bolt?
SOURCE: front engine mount torque spec
Tighten it until it strips and then back it off a quarter turn.
SOURCE: generator cover bolt pattern specs?
You can do the job yourself with no problem. No specific pattern for the side cover. BUT, get all the screws started then just bring them all slightly snug. Now tighten one screw and then go kitty corner and tighten another now drop down and pick a screw mid way between the first two screws and tighten it. Now do the kitty corner thing again and so on. As you know, the idea is to tighten the screws evenly around the entire cover.
As to torque, a 6mm screw gets 7 foot pounds or 85 inch pounds.
Realistically, no one ever bothers with torque on small screws. You will want to spend $15 to $20 and get yourself an impact driver to tighten or loosen screws. The tool is about 6" long and 2" in diameter and has a 3/8" drive on one end. Your socket set will fit it as well as screw driver bits. Just engage the bit into the head of the screw and strike the end of the impact driver with a hammer while twisting the tool to tighten the screw. This is the most valuable tool in my shop and I use one (Blue Point brand) that I got 40 years ago. They last well and can be used on any screw, bolt or nut that needs a little persuasion.
Please rate this solution as a "FixYa" if I have helped. Thanks!
SOURCE: what is the head bolt torque on a 1990 suzuki lt250r
The 8mm head bolts are torqued at 19 - 21 ft/lbs.
any smaller 6mm bolts are torqued to only 6 ft/lbs
like those on the lower cylinder.
SOURCE: torque settings for crankcase suzuki bandit 600gsf
Crankcase bolt (M8)
(initial):13 N-m (1.3 kgf-m, 9.5 lb-ft)
(Final):23 N-m (2.3 kg-fm, 16.5 lb-ft)
Please leave positive feedback if you feel I have helped.
Thank you
814 views
Usually answered in minutes!
×