I already checked my float and thats not it. but it keeps running through my over flow tube.
SOURCE: CARB PROBLEMS TTR 125 06 Reg
Hi,
Offhand, fuel overflow could be brought about by:
A seized starter plunger would have to be replaced. This problem could have been brought about by:
Just a start, do postback how things turned up or should you need additional information. Good luck and Thank you for using FixYa.
SOURCE: float hieght for 1984 IT 490
not sure of the exact height, but if you hold the carb level with fuel hose attached and pushing float up with finger, turn on petcok and slowly lower the float until it is just above horizontal. at this point, gas should start to flow out of the needle & seat.
if float turns off gas too soon, then engine will starve.
if float doesn't turn off gas, then it will flow out of the carb overflow tube.
SOURCE: My TTR 125 wouldn't start after being idle for
The adjuster tang on the float (in green) rises and falls to maintain fuel level. It pushes on the float needle to stop the flow and drops to let fuel in. Did you loose the needle? If all parts are there, gently bend the tang upward to lower the gas level in the carb.
A “very helpful” rating for this answer? Thanks!
SOURCE: 2000 yamaha ttr90 fuel leaking out overflow tube
your float is stuck take carburator off and clean wiggle float and it shouldnt leak gas anymore
SOURCE: gas running out rubber tube left side where the gas line tees
You have a stuck float, and need to pull the carb, and clean it out
1,123 views
Usually answered in minutes!
×