Hi . where is the valve timing mark on my kymco-125 hipster cam -sprocket.
the valve timing mark is on the flywheel on the Hipster's.
Remove the large flat blade screw from the top of the left hand side casing. Turn the engine either by hand (using kickstart with ignition off), turning rear wheel in gear, or by removing the "kymco" badge with three 8mm bolts and using a 19mm deep socket on the crank, until you see two marks (one says F one say T) the F one is the advance firing mark, the T mark is the timing mark. Keep turning the engine over and watch your valves, wait for the exhaust valve to close, inlet valve to open and then close again then the next time you see the T line will be TDC. This is where you set your valve timing from.
removing rear wheel for kymco 125
×