Indicators on bike flashing at about half speed

I suggest you buy a repair manual. Good to have for all details when you take on repair work on your bike. There should be several available, for example https://www.emanualonline.com/Motorbikes/BMW/F-Series/F650/F650CS/BMW-F650-CS-repair-manual.html

Your problem seems to be the rear brake disk,change it or have it rectified, you also will need new brake pads.

Sounds like a Idle Air or ECM problem...in ether case will be hard to locate w/o scan tool

You can purchase custom brake lines from Spiegler. Just have to measure the length that you need and tell them what fittings you want installed.

See website for Spiegler
http://www.spieglerusa.com/

Either there is a short in the wiring, or a cable is getting pulled.

motley45

this happens when the shutter speed is not correct. set the speed to 1/60 sec.
if the X-370 flash is new it may not be compatible with your camera. with the flash turned on it should set the shutter speed automatically to either 1/60sec or 1/125sec. looking in the finder the shutter speed should not change to various amounts of light. if the shutter speed changes with the flash turned on it is not dedicated to your camera.

Hi and welcome to FixYa,

In the brake pad replacement, perhaps this would help. On the workshop manual, please try here.

Good luck and thank you for using FixYa.

Sounds like not a problem at all. If this happens when just the ignition is on and before the bike has been started.- This is normal operation. The fuel is just signaling reserve as it does not yet have a reading and any oil light on any bike would stay on or flash before the bike has started/been running.

you have to remove the coils first