How to replace valve cover gasket on 01 pt cruiser 2.0 end no tubo
This procedure takes approx 3 hours.You have to remove upper intake manifold and cylinder head cover,in order to replace valve cover gasket.
Its a huge procedure,but can be done easily.
Click the link below and follow step by step details.
http://technoanswers.blogspot.in/2012/06/valve-cover-gasket-removal-guide.html
---------
This will help.
Thanks.
Here is the procedure:
You need to remove:
Upper intake manifold and spark plugs
In addition to
above and in order to remove the entire Upper Intake Manifold and have full
access to the Valve Cover:
-Disconnected throttle support (2 nuts),
disconnect throttle cables,
-Disconnected four (4) electrical connectors and
four (4) hose connections.
-Removed Ignition Coil Pack four(4) bolts attached
to top of valve cover
-Disconnected Spark Plug wires from Spark
Plugs
-Disconnected Steering Fluid reservoir two (2) bolts and tied it to the
side and out of the way.
-Removed nine (9) valve cover bolts and they stay in
cover if yo don't pull them out
-Very carefully cleaned the flat, top
surfaced with a one edged blade and a small chisel trying not to scratch the
metal but remove the build up of oil residue.
-Meticulously cleaned the valve
cover's outer perimeter and spark plug well channels of almost all the oil and
crud I found there. This with a clean rag and small screw driver covered by the
rag, folded 2 to 3 times.
-Cleaned all the threads of the cover
bolts.
-RTV gasket sealer at the specified corners in the Service
Manual.
-Replaced valve cover, torqued bolts to 105 in. lbs in three steps
and in the correct sequence: 40 in.lbs, 80 in. lbs and 105 in.lbs.
SOURCE: replace EGR valve on a PT Cruiser
The valve is located just above where the engine and transmission seam meets. There is the metal exhaust gas tube with 2x8mm bolts and a fiber gasket. The EGR mounts to the cylinder head with 2 10mm bolts and a metal gasket. There are 2 vacuum lines that go to the control solenoid, a black plastic pod moounted under the throttle body. It clips into the TB mounting bracket, and has a 3rd vacuum supply line and 1 electrical connector.
SOURCE: 01 PT Cruiser window won't go up Can hear motor
sounds like he broke the regulator and it will need replaced
SOURCE: Replacing Alternator For 2001 Chrysler PT Cruiser (Manual)
this instruction is general for all vehicles. i am sorry that i do not have particularly for your 2001 chrysler PT cruiser.
first, identify the alternator.
remove the fan belt on the alternator,
label and remove all wires that is attached to it.
remove all bolts that is holding it.
remove the old alternator.
do the reverse on installing it.
tnx 4 using fixya,
drcool
SOURCE: Location of powertrain control module on 01 PT Cruiser?
The PCM attaches to a bracket welded on the dash panel
SOURCE: timing belt replacement on 01 pt cruiser how many
Timing belt replacement may cost you a minimum of 4
hours, and a maximum of 6 hours. This depends on the
mechanic expertise and the service center facilities.
2,324 views
Usually answered in minutes!
×