Brother took engine apart to replace fuel injectors, left the truck for me to fix. He didn't label the vacuum lines. The diagram is under the hood, but not complete enough. Can't figure out whee the lines go. Example, throttle fuel pressure sensor has one hose connection that goes to the intake manifold, On the other end it has two hoses coming out the other end...where do they go. I need a good diagram.
SOURCE: 2003 Ford Taurus stalls at idle
go to autozone.com and register for free. You will then have a full free online repair manual with step-by-step directions, diagrams, troubleshooting, testing, replacing, and more. As an automechanic myself, this a wonderful site.
SOURCE: code was P1443. I put
you need to have the computer reset to get the check engine light to shut off there is a list of error codes that has to be cleared from the computer so the check engin light will shut off but it wont hurt to drive with the light on for a while as long as you fixed the problem
SOURCE: need diagram of vacuum hoses for 1993 ford
you need to change the modulator on the trans as its vacuum controlled and itsdamaged letting auto fluid get sucked up the line,(diaphragm probably split in modulator
SOURCE: Vacuum hose missing
Your PCV valve has two port's, it also should have came with a plug ( Plastic ) That you break off of the PCV and plug the small one.Canada Emissions is the only one that uses both port's.
SOURCE: Ihave a 2001 Ford Escape.
Check to see if the catalytic converter is plugged. An easy way to do it is to remove the oxygen sensor from the manifold or exhaust pipe (if it is located infront of the cat). This will open a small hole for the exhaust to escape from. If the cat is plugged, you'll see a noticable difference in power.
If you've had bad sensors, there is a chance it's plugged. You could remove it and try to blow the clog out with compressed air. If that doesnt work you'll need to replace it.
for a temorary fix, break the ceramic out of the inside of the cat with a bar or pipe. This may be illeagal and will throw engine codes if you have a O2 sensor after the cat.
960 views
Usually answered in minutes!
ok so any guesses on where the two hoses would go?Being they are from the throttle sensor valve? Or where I can go to get a better diagram? Chilton has the same diagram that is under the hood it is not complete
×