Engine miss at 45-55mph, no accleration with throttle response,

.As soon as I touch the throttle it will go to the sky.Have you any idea what that can be.Thanks. ... read more Doug E. Vintage M/C restorer Vocational, Technical or Trade Scho 2,485 satisfied customers1982 Honda Goldwing Aspencade: carburetor..bike..gas line..air filter I have a 1982 Honda Goldwing Aspencade, it has been sitting for about 2 years now, when I first got the bike I cleaned the carburetor, adjusted the valves, and did a oil change, I also cleaned the gas ... read more Doug E. Vintage M/C restorer Vocational, Technical or Trade Scho 2,485 satisfied customersI have a 1982 Goldwing GL1100. I have replaced the carburetor I have a 1982 Goldwing GL1100. I have replaced the carburetor diaphragms, the pilot jets, and the idle mixture screws. I have cleaned the carburetors. I have adjusted the valves. I have rebuilt the petcoc ... read more Doug E. Vintage M/C restorer Vocational, Technical or Trade Scho 2,485 satisfied customers1982 GL1100: carburetor..The bike idles fine

Dont Relpace Your Goldwing 1200 Fuel Pump right away ...

? 10:57
https://www.youtube.com/watch?v=pcEeGhvPxq4
Sep 18, 2012 - Uploaded by dawino6260
just a heads up, unless you have the fuel pump relay jumped out, it will not .... Honda Goldwing gl1200 Single Carb Coversion and Alternator ...

Gl1200 checking fuel pump relay - YouTube

? 0:21
https://www.youtube.com/watch?v=o2Kb16Iw3pw
Jun 12, 2012 - Uploaded by virgilmobile1
Gl1200 checking fuel pump relay ... Pt.2 1986 Honda XL600R How To Replace The Fork Seals - Duration: 8:56. by D-Ray Smith 20,179 views.

Location of GL1200 pump relay - Steve Saunders Goldwing Forums

www.goldwingfacts.com > ... > Forums > Goldwing Technical Forum

Oct 6, 2012 - could anyone tell me were the fuel pump relay is located on 1984 gl m1200 carburated . thanks. ... Model: 1987 GL1200 Interstate 280,000 miles. Posts: 13,512 ... ry=MOTORCYCLES&make=HONDA&year=1984&fv eh=3442 ... GL1200 SEI Fuel Pump
Nov 24, 2015
Fuel pump relay location on 1985 GL1200 Interstate?
Mar 22, 2015
1987 gl1200 SEI fuel pump psi?
Apr 1, 2014
GL1200 Fuel Pump
Jun 26, 2011
More results from www.goldwingfacts.com

check wiring at main fuse,86 sei has a defect that causes
melt down at solenoid. replace if defective.

normal for voltage to increase with RPM, normal for voltage to decrease as battery reaches fully charged. make sure connectors are clean and tight.

The GL1200 Aspencade fuel injection did not come with fuel injection. But a lot of those bikes have been piced togather from outher bikes.

The entire 1200 goldwing line had stator problems. First thing to check is the 3 yellow wires and the connector they have just to the left of the battery. Most people remove that connection and soder it after testing the stator. There is a complete checklist, along with alternative solutions at http://www.gl1200goldwings.com/ If you own a 1200, that is the best self help site for these bikes.

This sounds like a fuel flow problem. I suggest removing and rebuilding and cleaning the entire system, meaning Carbs, filters and strainers in the tank. Old fuel turns to gel, and floats absorb fuel, sometimes, so inspedt everything. When finished set carbs with carb sticks, both at idle and at 2000 RPM, using hand throttle.

Check the main fuel line to and from the filter as they get small holes in where the filter is replaced.

run an ohm test on the stator wires, make sure you get readings through all combinations of any 2 wires. if you don't get an ohms reading between 2 wires that means you have a broken stator winding and the stator needs to be replaced. hook up a volt meter to your battery and test battery voltage at rest (bike off), at idle (bike on and idling should be at least 12.5 - 13 volts), and steady around 3 - 4000 rpms (should be around 13-14.5 volts. if it exceeds 15 volts your regulator is bad and needs to be replaced. if all numbers are about what I said, have your battery tested. If your battery is over 1.5 years old it should be replaced anyway.

could be a out sinked carb or gum from sitting gas won't last long