SOURCE: fuel pump?
the fuel pump for your 2000 fuel injected road king is located in the fuel tank. you will have to remove the speedometer housing, by first removing the seat, then remove the one small screw near the seat that holds the speedometer housing in place, also remove the small screw at the front of the speedometer housing and lift the housing off the tank and disconnect the wiring that goes to the back of the speedometer. there is a large oval shaped gold in appearance plate on top of the fuel tank. this plate is what the fuel pump is mounted to.
SOURCE: delphi or magnetti marelli fuel injection
If you look at the top of the Induction module, you'll see if it is either black ( single looking tube ) or Silver ( Looks like 2 tubes together ) Single tube is Delphi, Silver Dual tube is Magnetti .
I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb
SOURCE: what size spark plug for a 2000 harley davidson road king carbed,
Your Twin Cam plug should be a 6R 12 Harley Plug. Often times the back fire is just the nature of the beast depending on what type of pipes you are running. Harleys do run lean, its an EPA thing thtas why they choke them down from the factory. Since you have a carb you could have an intake leak around the Intake. Also Under the carb is an adjustment screw. Harley plugs it up so people don't play with it. You have to just drill out the plug this will set your air fuel. Whenever I take a carb off I drill out that plug. Heat your bike up operating temp and ear tune that screw. Only other way is with air fuel analizer or a dyno. good luck.also that backfire is caused by fuel hitting your exhaust when you let off just to let you know.
SOURCE: need a manual for 2001 harley davidson road king
I believe the item number is 99483-01, it retails for 60 bucks. You will swear by it once you buy it. ;)
SOURCE: how to replace fuel filter on harley davidson 02
I am having problems viewing the reply but if you have a FLHRCI then to replace the fuel filter you will need to be prepared to put some time into it.
First remove the console off the fuel tank, one nut below speedo and the phillips screw lower close to the seat. You will have a disconnect on the top left side of the fuel tank to disconnect. Then disconnect the vent tube from the tank with a gentle pull & twisting motion. Now the fun part there are ten torx T20 screws you need to remove, but first you must go buy new ones along with the gasket and fuel filter kit. DO NOT reuse the screws. Now for whatever reason they call this piece a canopy, go figure. Once you have your parts go ahead and raise the canopy slightly and twist it to the left a little. Now this can be tricky because there is a spring loaded hng to work here, be care not to over stress any thing. Then you can begin to pull the canopy and components from the tank. You will be limited by the convoluted tubes (hose) attached as to how far you can raise the canopy, if you remove one be careful as where they attach is plastic and breaks....easily sometimes, then you need a $350 part.
Next read and look at the diagrams that come with your new fuel filter to install it. Once done carefully reverse the canopy removal process and tighten the canopy bolts in cross pattern o somewhere between 18-27 in-lbs. Hope this helps.
JP
2,050 views
Usually answered in minutes!
×