SOURCE: Harley Davidson street glide idles low and sometimes dies at stop signs?
2004 springer put plugs in fouled out in 5 minutes black smoke out pipes any suggestions
SOURCE: Fuel injection Harley Davidson 02 Fatboy
System is self bleeding. You may have disturbed some debris that has gotten in the fuel injector/s. Try running some fuel injection cleaner through it and see what happens.
SOURCE: link for down loading harley davidson road king repair manual
Not going to happen, copyright issues just like music. You may find it but.......
SOURCE: how to replace fuel filter on harley davidson 02
I am having problems viewing the reply but if you have a FLHRCI then to replace the fuel filter you will need to be prepared to put some time into it.
First remove the console off the fuel tank, one nut below speedo and the phillips screw lower close to the seat. You will have a disconnect on the top left side of the fuel tank to disconnect. Then disconnect the vent tube from the tank with a gentle pull & twisting motion. Now the fun part there are ten torx T20 screws you need to remove, but first you must go buy new ones along with the gasket and fuel filter kit. DO NOT reuse the screws. Now for whatever reason they call this piece a canopy, go figure. Once you have your parts go ahead and raise the canopy slightly and twist it to the left a little. Now this can be tricky because there is a spring loaded hng to work here, be care not to over stress any thing. Then you can begin to pull the canopy and components from the tank. You will be limited by the convoluted tubes (hose) attached as to how far you can raise the canopy, if you remove one be careful as where they attach is plastic and breaks....easily sometimes, then you need a $350 part.
Next read and look at the diagrams that come with your new fuel filter to install it. Once done carefully reverse the canopy removal process and tighten the canopy bolts in cross pattern o somewhere between 18-27 in-lbs. Hope this helps.
JP
169 views
Usually answered in minutes!
×