How do i remove the drivers seat on a 2008 zx10

Howdie you will have to drop it out from the bottom very carefully don,t tip it over will cause Leakage or go to the Dealer HAnd them a 20 and Be NICE to them for imfo to help ya out thks again for your time

Hi,
I have an '07 C50c Metallic Silver/Tribal.
To remove driver's you have to remove passenger seat first
Remove bolt holding down rear of passenger seat
(s/b 1 Hex-key/Allen hd. bolt)
Lift rear end of seat and pull back to release
You will then see the (2) bolts holding the driver's seat (and passenger grab-strap) down.
Remove bolts, lift and pull toward the back of bike to release
That should take care of it...half of it anyway!
(Hope I didn't forget something important)
Good luck!
- "Ride like they're all trying to run your @$$ over" - k.w. smith

is there a strap or clamp securing it ?

most likely bad connection remove it and clean the contacts it should work then

take the side fairings off and there are two bolts you'll need to back out. one bolt on each side

Checking the size will instantly tell you.

take side fairings off. remove two bolts on seat one on each side. fuse box under sea

Remove the small triangle shaped black plastic pieces below the seat by pulling on the tip closest to the rear of the bike. Once these are removed there is phillips head screws on each side.

THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 08-006-08, DATED
FEBRUARY 22, 2008, WHICH SHOULD BE REMOVED FROM YOUR FILES. ALL
REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDE AN UPDATED
OVERVIEW, REPAIR PROCEDURE AND LABOR TIME.
THE StarSCAN® FLASH FILES FOR THIS BULLETIN MUST BE RETRIEVED FROM
THE INTERNET.
StarSCAN® SOFTWARE LEVEL MUST BE AT RELEASE 8.05 OR HIGHER FOR THIS
BULLETIN.
StarMOBILE STANDALONE MODE OR StarMOBILE DESKTOP CLIENT MAY ALSO
BE USED TO PERFORM THIS PROCEDURE.
SUBJECT:
Flash: Driver/Memory Seat or Driver Power Seat Functions Intermittently
OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Memory Seat Module
(MSMD) **and performing calibration on the MSMD with the STARScan.**
MODELS:
2008 (KK) Liberty
2008 (RT) Caravan/Town & Country
NOTE: This bulletin applies to RT vehicles with sales code JT2 and KK vehicles with
sales code LEW built prior to September 21, 2007 (0921XXMDH).
SYMPTOM/CONDITION:
The driver/memory seat and or driver power seat functions can become intermittently
inoperative due to a Memory Seat Module software issue. A software design change has
been made to eliminated these intermittent conditions.

Unlock the pillion pad, remove the allen key from under it, then remove the two semi circular grommets at the rear of the riders seat. This will expose the two fixings that hold the seat in position, they can now be undone with the allen key.