Torque setting for cylinder head needed.
SOURCE: Need cylinder and cylinder head torque specifications 98 XR 250
you dont need torque specs on that just use a 1/2 inch drive with you 14mm or16mm socket hold the wratchet right at the top and tighten it as tight as you could get it like that then use wratchet in normal position and just give it a little snugg it will be perfect i have done it a million time on the same type of bikes...
SOURCE: Need torque wrench settings for cylinder head bolts
try here http://www.manualz.info/
hope this helps
SOURCE: need torque settings for 1985 4A corolla cylinder head
hey, torque must be done in 3 steps:
1st 22 ft lbs
2nd 43 ft lbs
final 47 ft lbs
use this sequence of tightening:
9 - 3 -1 -6 -8
7 - 5 - 2 -4 - 10
SOURCE: polaris 455 diesel head torque settings and cam timing
Buy the factory shop manual
Note these engines appear to spin a bearing I think on the vibration damper countershaft and blow through the side of the engine. If you hear any different noise out of the engine, shut it down and take it apart. Mine started at about 2000 Hours
SOURCE: cylinder head torque settings 1990 2.6L isuzu motor
From front to back is this:
7 3 1 5 9
8 4 2 6 10
First torque value is 58 ft lbs.....then final torgue is 72 ft lbs.
666 views
Usually answered in minutes!
×