- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There could be a few different things causing your Landice L7 treadmill to race to top speed when turned on. Here are some potential causes and solutions:
Motor Control Board: The motor control board may be malfunctioning and sending the treadmill into top speed automatically. If this is the case, you will need to replace the motor control board.
Console Board: The console board may be sending incorrect signals to the motor control board, causing the treadmill to race to top speed. If this is the case, you will need to replace the console board.
Speed Sensor: The speed sensor may be malfunctioning and sending incorrect signals to the motor control board. If this is the case, you will need to replace the speed sensor.
Calibration: The treadmill may be out of calibration, causing it to race to top speed. To recalibrate the treadmill, consult your owner's manual for instructions.
It's recommended to consult with a qualified technician to diagnose and fix the issue to avoid causing further damage or injury.
In December 1983, Car and Driver clocked a four-speed Fiero SE from 0-60 mph (0-97 kph) in an uninspiring 11.3 seconds, reaching a top speed of 105 mph (169 kph).
If it is the original exhaust system, I suspect a blockage, causing excessive back pressure causing lack of performance. It may be the carb has a blocked choke? Hope this helps.
To improve top speed,one solution is to change your gearing, via the chain and sprocket set up. To gain more top speed, you need to replace your rear sprocket with a smaller one, say about 5 or 6 teeth less. Also the front sprocket changed for a slightly larger one, usualy 1 or 2 teeth more. Note, that while doing this will give you a greater top speed, it will not make your bike more powerful. A power pipe, or aftermarket muffler would be a great improvement too.
Hi les
Not much to start with here unfortunatly mate. A free flow muffler will help top end speed, change the factory airbox to a K&N style pod air filter, other than that, hugging the tank at top speed :) If you do change these parts, you may also need to increase the main jet size to richen up the mixture for better tuning of the motor with the better flowing parts. This bike has a top speed of 100kmp and produces 10 hp, so you may only expect to get at best less than 1 extra neddy, and perhaps another 5 km/hr.... I suggest upgrading to a bigger machine of you feel the need for speed :)
If its 125's you are into, test drive a Honda CBR 125R 6 speed fuel injected 13.4 horsepower, and good for 120km/hr
regards
robotek
Hi, just fixed the daughters speed queen, same problem. The three brake shoes were worn allowing the tub to spin with the agitator.
replaced the shoes, washer fine. At first I thought it was the top ring. spent 30 dollars for nothing.
good luck
×