1989 1100 virago
SOURCE: Yamaha Virago XV700 - 1987 Seat Removal
Most Yamaha models have 2 bolts holding the seat on, usually located between the top shock mounts and the side covers. You should be able to find them without too much trouble, but remember- they are metric. Hope this helps.
SOURCE: how do you remove seat from yamaha virago 1985,
There should be a key lock on the right side of the bike about half way back from the front of the seat. Put the ignition key in and turn it.The seat should lift up and you shuold see a 4 to 6 bolts holding it to the frame.
SOURCE: removing the seat from my 1990 Virago
there are 2 allen head cap screws at the fromt of the seat underneath the side covers that hold it in place
SOURCE: needle n seat adjustment yamaha virago 920
Hello dnjvp...The Hitachi HSC 40mm carbs on the 920 can be jetted and modded as needed to give you the right mixture for any engine or exhaust modifications.
Here is the breakdown for the slide and the internal parts. Check the needle for wear, clean all parts and put back together. Make sure you hold the diaphragm up to the light and check for pinholes. If any are found use a sealer like to fix.
Good luck...i hope this helps.
SOURCE: How can I remove the rear seat of a Yamaha Virago
The rear seat is held in place with a single bolt near the rear of the seat. This bolt is normally a socket head type (you use an allen key to remove it), is near the centre of the rear fender and also usually holds the rear rack or grab bar in place. Once the bolt is removed you may need to shift the rear of the seat sideways one way or the other in order that the tab on the seat clears the grab bar or luggage rack. The front end of the rear seat is secured under a tab so after removing the single bolt, simply slide the seat toward the back of the bike and it will come free.
530 views
Usually answered in minutes!
×