I am changing the head light housing with a neo and the wireing that came with the new unit is different. The old one has 3 wires coming from the housing/lamp. (white, yellow, black). The new one has 5 wires. One yellow, one white, 2 black, and one yellow with a male connector on it. How do I Chang this out correctly? Where do the extra black and yellow wires connect to?
SOURCE: 2007 Harley Fatboy Taillight problem.
Check to make sure BOTH light filaments are intact. Or try another bulb to double check the situation before wasting to much time on a simple fix.
SOURCE: i want to hard wire my headlight,spot lamps and front signals
hey, thanx anyway but i took the time and blew 4 fuses before i figured out the wiring . i had done it in the day, but not for the last 20+ years, and todays hogs are a little more harder, but not impossible, thanx anyway but i just can't see me paying u to help. i guess the day when a biker helped a biker and just took pride in his work, not money. well there's a surprise, maybe thats the way it is for most, but not i. hey i dare u to print this review,-and no problem cause i asked u to help, u didn't offer, oh ya u did 4 $$$$$$$$$$$$$- later G.K.B.S. p.s. don't cut all the prongs off and have just bare wireing, cause it's a hell of a lot harder, ha-ha
SOURCE: How to wire a tach on 05 heritage softail
Locate & route Black lead to ground / 2004-later softail: On the frame strap under the seat directly in front of the battery.
Locate & route the pink lead to Signal / For 2004 & later FXST/C/I The #3 cavity in the connector {39b} on the back of the speedometer. The socket terminal on the signal (pk) lead fits the #3 cavity.
Locate & route the Orange and white lead to power / Ummm.. it's saying for 2004 and later to adapt to the fuse block For earlier [ For 1996 to 2003 softail: locate the power lead (o/w) in the tail lamp pin connector {7a} under the seat behind the right rear corner of he battery.] "here you are looking to run it to a fused line, not directly to power/battery" I hope this helped.
SOURCE: 2003 HD Fatboy has a miss. New plugs and wires.
i take it its carb. after it warms up to operating temps does it stop the sputtering? thats just a HD CV carb doing what it does til hot. Im not talking a 2 min warm up and off u go im talking operating temps of 200 plus. Is the carb an S&S? Your going to have high rpms til the temp kicks it down if its injected
SOURCE: picture wiring diagram for 2003 harley fatboy
May I suggest a trip to your local library. Cycle repair books should be in 646 stacks of reference.
Otherwise you can Google for 2003 Clymer Service manuals on the internet.
I think Clymer had electrical diagrams in their books. I doubt that any except the HD service book would have anything about the physical location of the harness, but the pictures in the other books would help you.
875 views
Usually answered in minutes!
×