Anonymous Posted on Mar 07, 2012

2009 ultra classic ABS code reset - 2000 Harley Davidson FLHTCUI Electra Glide Ultra Classic

2 Related Answers

Anonymous

119 Answers
Posted on May 20, 2010

SOURCE: how to reset abs sensor on a ultra classic

on a 2000 Ultra there is no ABS so there is no ABS sensor either.

Anonymous

345 Answers
Posted on Jul 29, 2010

SOURCE: 2009 Harley Davidson Ultra c;assic headlight is

You say there is power at the fuse. ok . You need to also check now if there is power to the headlight and spotlights, if yes, then it is possible your globes have blown. If no power to the back of the lights, then the problem exists in your lighting switches.

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

2009 Harley Davidson FLHTCU Ultra Classic Electra Glide ABS brakes not working properly

Duplicate question already answered

Read full answer

Aug 06, 2018 • 2009 Harley Davidson FLHTCU Ultra Classic...

0helpful

1answer

Hi I have a abs light on my 09 ultra classic i want to know how i can turn it off Thanks Keith

You need a code reader with abs support to reset the light.

Read full answer

May 27, 2018 • Ultra Motorcycles

0helpful

1answer

What is a abs code 1250 on a 2009 ultra classic?

Indicates a problem with the fuel pressure. Code could be caused by excessive tank pressure, (loosen fuel cap then tighten). Code may not clear right away. Could also be a plugged fuel filter or a defective fuel pump. Hope this helps.

Read full answer

Aug 27, 2014 • 2009 Harley Davidson FLHTCU Ultra Classic...

0answers

Abs light is on

Read full answer

Be the first to answer Jan 26, 2014 • 2009 Harley Davidson FLHTCU Ultra Classic...

1helpful

1answer

How to read engine codes on 2009 harley touring

I have a 2008 Road King, so I imagine the method to retrieve the codes would be the same.

Retrieve fault codes:

With engine run/stop switch in the RUN position, hold odometer reset button while turning ignition switch to ON position.

Speedometer back lights wil come on, needle swings to top speed position, indicator lights will come on.

Release reset button.
"diag" should display in odometer.
Push and release odometer reset button. The letter "P" will flash (ECM/ICM info obtainable).
Record any error codes. If none are present, "NONE" will scroll across screen.

Press and hole reset button for more than 5 seconds to go to next mode ("S" = TSM/TSSM/HFSM mode).

When done with all modes, switch off ignition.

Either look up codes in manual, or repost here.

Read full answer

Mar 19, 2013 • 2009 Harley Davidson FLHTCU Ultra Classic...

0answers