The neutral light stays on when my Yamaha fz6 is in gear I have replaced the neutral switch but the light stops on I have cleaned all the connections to the switch checked the battery terminals replaced the neutral switch cleaned the side stand kill switch too, is there anything else behind the engine case covers I could have a look at? I can't find where the bike is earthed to from the battery as I thought it could be a badly corroded earth connection? Any ideas?
SOURCE: 2000 yamaha vstar 1100 custom. starter problem?
I had the same problem 2001 XVS1100 Custom
this is a starter issue Over time the starter on this bike twists when its under a load.
Look at the two bolts holding the starter on if they are not straight across then its twisted. turn starter back in line with a pair of big channel locks and try to start this should do the trick if this works i would recommend taking the two bolts out and bend them back straight or replace and reinstall starter this should fixya problem
Hope this helps ...............Jimmyfixya
SOURCE: Side stand kill switch
follow the wires to the side stand there should be 2 wires disconnect 1 wire either by the little plug or by cutting wire
SOURCE: Intermittent problem with neutral light on a 2002 R1
The neutral swich is located behind the front sprocket cover
Ride Safe
Bike-Doc
Please mark this as helpful (if it has been!!)
Testimonial: "Hi,thanks, found it. Very useful Pete"
SOURCE: where is the xt600e earth/ground wire connection
If your negative battery cable has been disconnected, and you can't tell where it goes, anyplace on the metal frame where you can make a good connection will be ok. You will need a sturdy bolt that you can tighten enough.
SOURCE: need apaint code for yamaha fz6 black
Look @ colorrite.com for your bike...........I'm not seeing the black on that bike
344 views
Usually answered in minutes!
×