SOURCE: carburetor specs
if you lift he floater you must have a clearance of 2mm on the top of the inner side of your carburator so it wont leak.
SOURCE: float height 1996 gsx r750T. Where exactly on the
you put it on the float base and allow the float to drop down and read the gauge where the float is read the top of the oppiste side where the float is hinged.
SOURCE: what is the float height setting for a 1984 harley
With the float bowl off and the float assembled in the carb, hold the carb on it's side with the needle and seat hinge upwards.
Set the float height to 0.630" to 0.670" (16-17mm) from the "bottom" of the float to the gasket surface where the float bowl gasket seal is.
These carbs are notorious for leaking past the needle and seat even when the float level is set correctly. They make a tool for refurbishing the seat in the carb as it is not replacable but the tool is very expensive for what it is and the amount of use will get out of it ($100). Sometimes I've set the float level an additional 1mm low (18mm) to put more pressure on the needle if it does leak. Good Luck!
SOURCE: What is the float height on a yamaha pw80
The float bowl level is set in between running it dry at full loaded throttle and fuel overflowing from overflow hose. The floats have a small brass tab that bears on the needle, when it rises, it pushes needle into seat and restricts fuel. Set this tab level with rest of tab plate surrounds for the middle fuel level position. Bending tab down will let more fuel in, up for less.
Better to put up with a little fuel overflow when you lay it down than starving motor of fuel when you need power the most. Damage can result running too lean.
Cheers.
806 views
Usually answered in minutes!
×