Help to fix petcock on 2000 harley davidson XLH sportster 883 hugger
SOURCE: need oil routing diagram for 1989 harley davidson
Little tip -The only time the oil cooler will cool is when the bike is moving and when the bike is moving you don't need the oil cooler. This is from a factory harley tech.
SOURCE: 2003 Harley Davidson Sportster 1200 Custom Tachometer kit
The only idea that i can come up with is that you dont have a good ground..or the guage was bad when you bought it..i hope this..Keith
SOURCE: Throttle to engine problem on 1993 Harley 883 Sportster
You either need to lube the cables, or adjust them. You adjust the throttle to have a 16th to an 8th inch of freeplay with the bars like youre riding straight. You adjust the snap back with the bars fully to the right. As far as the motor shutting off , you need to use the enrichner ( they call it a choke) until it will idle on its own without rapping the throttle. Also , your idle may be set too low on the carb. The adjustment is made at the idle speed screw , right behind the air cleaner.
SOURCE: Adjusting timing on Harley Davidson 1976 sportster
The advance timing should be 35° before Top Dead Center. This is how you find out which mark this is.
Get the rear wheel of the bike off the ground, remove the spark plugs, shift the bike into fourth gear, and remove the timing plug from the left engine case.
Now, take an ordinary PLASTIC DRINKING STRAW and insert it into the front spark plug hole. Do not use anything else or you stand a chance of it breaking and then you'll have to pull the head to get it out. The plastic straw will bend but not break.
Bump the rear wheel in the direction that it turns while riding down the road until the piston pushes the straw all the way up and just barely starts going back down. Look into the timing hole. You should see a timing mark. This is the Top Dead Center mark. Now, bump the rear wheel BACKWARDS until you see another mark. This should be the ADVANCED TIMING MARK. The piston should 7/16" down from top dead center.
On this model Sportster the timing is advanced by a mechanical advance mechanism. These units are notorious for wearing out and not contolling the timing very well. You must remove the breaker plate to inspect this mechanism. Mark the position of the plate before you remove it. If the pins and holes in the flyweights are worn, replace the unit. Replace it with a good needle bearing unit. Replace the points and reset the gap at 0.018 - 0.020".
SOURCE: 2000 Harley Davidson XLC Sportster 883 won't start
the heat from the bulb being continiuosly on may have melted a wire inside your headlight?
281 views
Usually answered in minutes!
×