Just purchased bike for my son i was told by seller that it just needed a cable replaced cable and still not working if you pull in the clutch it stays in gear
SOURCE: bike stays in gear with clutch in
You are saying that with the clutch lever pulled in the bike still wants to go forward. Generally that is caused by dirty, gritty oil in the gearbox. Go ahead and change the oil. 10w40 motor oil is what you want. I think that will fix the problem assuming the clutch plates were installed properly. The first plate installed and the last plate installed should be a fiber friction plate, 8 plates total. A metal pressure plate goes between each fiber plate, 7 plates total.
Be sure the lever assembly arm is installed so that it gets full movement of the clutch cable. If the full range of movement is not present then full disengagement of the clutch is not going to happen.
cape cod bob did you a good service in the manual referral. Be sure to say thanks.
SOURCE: 2003 KX125 Clutch Problem
have you checked the basket for groves? if it is groved the plates will stick the release all of a sudden.
SOURCE: my 1986 kx 125 clutch does not engage worked prior
possible the cable is needing to be adjusted make sure it is pulling on the pivot
SOURCE: clutch not working
What type oil in your crankcase? Wet clutches go on strike with wrong oil. Engine oil is a no no.
SOURCE: clutch slipping
i have a honda cr 125 i put a new clutch , springs and 1st 2nd 5th are good but 3rd 4th are slipping. can some give me some help ! thank you
323 views
Usually answered in minutes!
×